UltraLux LLBS36CCT LED Lighting Fixture Instruction Manual
- June 3, 2024
- ULTRALUX
Table of Contents
LLBS36CCT LED Lighting Fixture
Instruction Manual
LLBS36CCT LED Lighting Fixture
Th is product contains a light source of energy efficiency class E.
| Model | Power | Length |
|---|---|---|
| LLBS36CCT | 36 W | 1200 mm |
| LLBS44CCT | 44 W | 1500 mm |
-
Turn off the power.
-
Remove the PC diffuser from the aluminium base by sliding the locks marked with the word “SLIDE” on both sides of the fixture.
-
There are two ways of surface mounting:
A. Back wiring
B. Side wiring -
Make an entry hole atthe indicated places.
-
Fix the aluminium base to the wall/ceiling.
-
Connect the input wires to the terminal block according to the marking.
-
Select the required colour temperature sliding the switch inside the body of the fixture. The luminaire must be powered off during this process!
-
Assemble the PC diffuser and the aluminium base.
Turn on the power.
NOTE: READ THE INSTRUCTIONS BEFORE MOUNTING!
- Performing any activity with the power supply on constitutes potential hazard of electric shock. Prior to mounting, power supply must be switched off by using the main switch.
- The fixture can be installed only on a flame-resistant base with ignition temperature at least 200C and does not deform or soften (e.g. metal, concrete, plaster).
- Activities related to connection to the power supply are to be commissioned to a person with appropriate authorization.
- The fixture, when properly assembled, may only be connected to a properly functioning electrical system with compliance with the applicable standards.
- Connect the fixture to the electrical supply, observing the correct polarity. (L) LIVE=BROWN; EARTH=GREEN/YELLOW; (N) NEUTRAL=BLUE
- All conductors and fitting auxiliary components are to be placed on AP-pro-prim ate distance from the heating parts of the fitting. When choosing the place for mounting, the required minimum distance must be kept between the fitting and the lightened objects.
- Prior to replacing, it is necessary to cut off the power supply by main switch.
- Clean only with dry cloth.
- The light fixture heat itself while working, so in case of necessity prior to undertaking its replacement, wait until cool down.
- If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
- Do not cover the fixture. To avoid any fire hazard, provide unrestricted air flow to the heated fitting parts.
- Not suitable for accent lighting.
- Prior to starting operating, make sure the mounting of the product has been performed appropriately, eliminating the hazard of defective operation, not endangering the surrounding and the users.
- The importer/supplier bears no responsibility for damages resulting from failure to comply with these instructions.
TAKE CARE OF THE NATURAL ENVIRONMENT CLEANLINESS
The products and its components are not dangerous for the environment.
Please dispose all the package elements separately into the appropriate
corresponding material containers.
Please dispose all broken lighting fixtures separately in containers for out
of usage electrical equipment. Before disposing the WEEE contact the
importer/supplier or refer to the guidelines of your local environment
protection organizations.
| 
---|---
https://eprel.ec.europa.eu/qr/1282836|
https://eprel.ec.europa.eu/qr/1282961