RF VENUE D-ARC Diversity Architectural Antenna for Wireless Microphones Instruction Manual
- June 3, 2024
- RF VENUE
Table of Contents
RF VENUE D-ARC Diversity Architectural Antenna for Wireless Microphones
OVERVIEW
Use this template for drilling. Refer to instructions on reverse for hardware and installation.
Instructions for Use
-
Remove bracket from back of antenna (a screw on either side holds it in place, leave them threaded into the bracket for easier installation)
-
Use the provided template on the reverse of this page as a drilling guide
Junction Box Mounting:
Use screws and wall anchors as required in at least 2 of the “J” holes.
Ceiling Mounting:
Use screws and wall anchors or toggles as required in at least 2 of the “L” holes.
Wall Mounting:
Use (2) screws and wall anchors as necessary in “K” holes.
OR
Use screws and wall anchors as required in at least 2 of the “L” holes.
Note: Be sure to orient the cable cutout on the correct side for your cable routing -
Connect both cables on the Diversity Architectural Antenna to coax cables and route through cutout in the side of the bracket or the junction box cutout
-
Use the 2 screw holes on the sides of the bracket to mount the antenna to the bracket.
Suggested Mounting Hardware (not included)
-
Junction Box Mounting:
For “J” holes:
Use at least 2 screws: 6-32, 8-32, or as required for your box -
Ceiling Mounting:
For “L” holes:
Qty 2: 1/8” Toggle Bolt, 6-32, 2” long
Qty 2: 1/4” x 1 1/4” OD Fender Washer -
Wall Mounting:
For Keyhole “K” holes:
Qty 2-4: #6 or #8 screws
OR
For “L” holes:
Qty 2: 7/8” Drywall Anchor
Qty 2: #6 x 1” Pan Head Sheet Metal Screw
Also required
The Diversity Architectural antenna has 2 elements and uses 2 coax cables (not included).
©2022 RF Venue, Inc Tel – 01.800.795.0817
- Fax – 01.617.752.1942
- orders@rfvenue.com
- www.RFvenue.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>