BLANCC BIS794 Digital Safe Instruction Manual

Digital Safe BIS794
Instructions Manual
keep this manual

Made in China
Bis shops BV
Herengracht 338 1016 CG Amsterdam The Netherlands

INSTRUCTIONS

1. INSTALLING THE BATTERIES – The safe requires 4 size “AA”(1.5V) batteries. The batteries compartment “Y” (see diagram 1) is located on the back of the door. Remove the battery cover and install the batteries into the compartment. Ensure the batteries are fitted with the correct corresponding polarity. Once the batteries are installed, close the battery compartment.
2. PROGRAMMING THE CODE – A. Press the red button “X” behind the door while the door is open, the yellow light will come on and give a short beep. B. Now press from 3 to 8 numbers that you wish to use as a combination, and confirm by pressing the letter “E” within 30 seconds. Or you have to restart from A. C. Write down your new combination immediately and check whether your new combination has been programmed with the safe door open.
3. USING YOUR SAFE – To open the safe, enter your personal code and confirm by pressing the letter “E”. You will hear a beep and the green light will be on, then open the door using the knob within 5 seconds. If the wrong digit is input, you can press “C” to cancel it. If you or an intruder uses the incorrect group of numbers, it will not open. If the incorrect combination is used 3 times consecutively, you must wait for 20 seconds before reattempting. If again the incorrect combination is selected 3 times, you must wait approximately 5 minutes before reattempting access. NOTE: Each number pressed will make the yellow light flash with a short beep, indicating that the microprocessor confirmed it. If the yellow light keeps on flashing with the beep it means the code is wrong.
4. REPLACING THE BATTERIES – The safe requires 4×size “AA” (1.5V) batteries. Open the safe, remove the battery cover plate “Y” (see diagram 1) on the back of the door and replace the 4 PCS old batteries. You must reprogram the code, using the above third step. Use of alkaline batteries is recommended.
5. OVERRIDE INSTRUCTION TO OPEN THE SAFE – For your convenience, we have engineered a manual override system for your safe. If you forget or misplace your combination, remove the small central cover “Z “(see diagram 2) between knob and keypad, insert the key into the keyhole and turn it in a counter-clockwise direction, then turn the knob in a clockwise direction towards the right. This will manually open your safe at any time.
6. INSTALLING THE SAFE – To reduce the risk of theft of the safe, it can be secured to floor, wall or in a cupboard. For your convenience, there are holes (diameter 8mm) both in the bottom and on the back; therefore it can be fixed by expansion bolts.

MAINTENANCE

• ­If the batteries are low, the red light (in the left) will warn you immediately. To test the batteries, just input your personal numbers to open the door. If the batteries are low, the red light will be on. If nothing happens, it means that the batteries are in order.
• After removing the batteries for a longer period of time, you need to set a new code

WARNINGS

1. Before using the product, it is important that you read all instructions and warnings carefully. Ignoring the warnings and instructions may lead to damage to the product or serious injury.

2. Before assembling the product, we recommend that you check all parts for damage and completeness.
   If any part shows a defect, please contact the customer service immediately.

3. Only use this product in combination with the original parts.

4. Repairs to the product should only be done by specialists or professionals. Never attempt to repair the product yourself!

5. Bisshops cannot be held responsible for damage or injury if the product is used incorrectly.

6. All information in this manual is correct at the time of printing. Nevertheless, Bisshops has the right to change the information without giving notice to update existing operating instructions.

7. Please keep this form with instructions carefully in order to use it again in the future if necessary.

8. Bisshops B.V. cannot be held liable for any damage or loss of property due to the use of this product.
   The product is used entirely at the owner’s own risk.

9. Do not keep the keys in the safe itself.

10. The safe must be installed horizontally.

11. Mount the safe in a fixed place to prevent theft.

12. Do not sit on the top box

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>