ITC 69724 and 69725 Exterior Docking Light Installation Guide
- June 3, 2024
- ITC
Table of Contents
ITC 69724 and 69725 Exterior Docking Light
PARTS/TOOLS NEEDED
IMPORTANT SAFETY INSTRUCTIONS
READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL IN-STRUCTIONS
- Disconnect power before installing, adding or changing any component.
- To avoid a hazard to children, account for all parts and destroy all packing materials.
- It is recommended that fuse protection be added to the positive(+) input.
INSTALLATION INSTRUCTIONS
Bracket Mount:
- Disassemble light from bracket by removing set screws on side of light
- Drill a 3/4” hole into mounting surface
- Feed wire through center hole on mounting bracket, and attach wires to power source (red is positive and black is neutral)
- Install provided screws through mounting plate into deck and tighten securely
- Reinstall light to bracket with side set screws
Recessed Mount:
- Remove bezel if not already disassembled
- Use 3/4” holes saw spaced 1.75” apart on center. Connect holes to create 2.5” installation cutout
- Connect wires to power source (red is positive and black is neutral)
- Feed wires back through the hole and screw the light in place using the screws provided
- Reattach bezel
For warranty information please visit www.itc-us.com/warranty-return- policy
3030 Corporate Grove Dr. Hudsonville, MI 49426 Phone: 616.396.1355
itc-us.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>