TOPMAQ Bree 30W LED Wall Pack Light User Manual
- June 3, 2024
- TOPMAQ
Table of Contents
TOPMAQ Bree 30W LED Wall Pack Light
Notes before installation:
- Please read LED Wall Pack light use manual carefully before installation and follow the instructions.
- To avoid accidents like damage, dropping, electric shock, fire, please don’t arbitrarily retrofit or change any lamp fittings.
- Clean lamps with a soft wrung-out soapy cloth, and then wipe it with a dry cloth. Please don’t wipe the lamps with gasoline or other volatiles. Please don’t spray insecticides on the lamps. Otherwise, it may cause discoloration or damage.
- Please do not open the lamp without permission.
- Please turn off the power when in installation or maintenance.
Technical Parameters
Model name
| Input Voltage| Power| Ingress Protection
---|---|---|---
BR-WP20W-01-G1| AC100-277V 50/60Hz| 20W|
IP65
BR-WP30W-01-G1
| AC100-277V 50/60Hz| 30W|
IP65
Dimension Diagram (mm)
Outdoor LED Wall Pack Lighting with Light Sensor
Start within 50 LUX Close above 150LUX
Application
LED Wall Pack Light series can be widely used as Exterior or interior LED lighting for Hotels, Garages, Commercial Buildings, Public areas, Schools and Hospitals,etc.
Installation instructions
P1-Mounting with J-box ( Caulk to mounting surface at all sides )
P2-Mounting with a 1/2” conduit at the bottom ( Caulk to mounting surface
at all sides )
Attention
- Install by qualified electricians only .
- Make sure that the supply voltage is disconnected before installation.
- Make sure the voltage is suitable with the lamps ,And L/N/G connect properly.
- All the lights during installation or using should not be lens’s cover vertical upside or Vertical down.
- Don’t open the lamps without Manufacturer’s Authorization.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>