VIGILATE VIGOSB Wireless Outdoor Siren and Strobe User Manual

June 3, 2024
VIGILATE

VIGILATE VIGOSB Wireless Outdoor Siren and Strobe

Product Overview

The wireless outdoor siren and strobe is an accessory of the VIGILATE smart alarm system.
It has an extremely powerful 115dB outdoor siren and could has a standby time of up to 36 months using 3xD(LR20) dry cell batteries. Mount it on the outside of the house and show potential burglars that your home is protected. It’s simple to setup, reliable and safe, and is equipped with core microprocessor and anti-tamper function. It will alarm and push notifications will be showed in the
App when it is tampered.
The light indicator will light up once every 15 seconds in the event of low battery and a push notification will be sent to the APP.

Specifications

•  Power Supply DC12V 1A
•  Battery 3 x D(LR20) dry cells
•  Transmission Distance Up to 1000m Line of Sight
•  Standby Current ≤110µA
•  Working Current ≤400mA
•  Siren Volume 115dB@30cm
•  Lens Colour Blue

℃ ℃

•  Working Temperature| -20 ~60
•  Humidity| 90%rh(non-condensing)
•  IP Grade| IP54
•  Bubble Level| Yes
•  Tamper Device| Supported
•  Prompt Light and Tone Adjustment| Supported
•  Battery Standby Time| 36 Months
•  Housing Material| PC+ABS+Anti-UV
•  Weight| 765.9g(battery not included) 1185g(battery included)
•  Dimension| 277.5x233x75mm   (LxWxH)(±0.1mm)

Appearances

VIGILATE VIGOSB Wireless Outdoor Siren and Strobe-1

VIGILATE VIGOSB Wireless Outdoor Siren and Strobe-2

Pairing with main panel by App
  1. Install the batteries and turn on the siren. Make sure the indicator is flashing, otherwise please reset it.
  2. Scan the QR code on the siren with APP.
  3. The pairing can be confirmed in App and the siren will beep twice.

Test: You can also press “Test” button in the App to check whether the siren is paired successfully or not.

Settings

Lighting Effects(Configurable)

Working Status Home Arm Arm Disarm SOS
Lighting Position Right Left Both Both
Lighting Modes Flash/OFF Flash/OFF Flash/OFF Flash Sharply/OFF

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment of and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference.
  2. This device must accept any interference received, including interference that may cause undesired operation.
    Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals