HAGiBiS XZ-G6W-TX 2-In-1 Wireless HDMI Extender and Wireless Display Dongle User Manual
- June 6, 2024
- HAGiBiS
Table of Contents
User Manual
Wireless Display Dongle
Connection Diagram
Packaging
- Product
- Power Cable
- Instructions
Hardware Casting
Combination of receiver and transmitter, plug and play
- Connect the HDMI port or VGA port of the receiver to the video input port of the display device such as the monitor or TV
- Connect the Micro USB power supply port of the receiver to the charging cable and plug it into the power adapter (Voltage above 5V, current above 2A).
- Adjust the HDMI signal source of the monitor or TV to the corresponding HDMI port until the boot screen is displayed.
- Connect the transmitter to the computer or other devices with HDMI video output function. After the indicator light enters the fast flash state, wait for ten seconds to complete casting.
- Please make sure that the power of the computer is sufficient. If the power supply of the computer is insufficient or HDMI is unable to supply power, please connect the transmitter to the power adapter or USB power supply port (Voltage above 5V, current above 2A).
Pairing Instructions
The product has been paired out of the factory. In case of pairing failure due to improper operation or other circumstances during use, it is necessary to restore and repair the device as follows:
- Please use the thimble to press in the small hole at the bottom of the receiver for 3-5 seconds, and the prompt will pop up on the interface: A 5E1-4:4t. Wait for the transmitter to enter pairing mode.
- Press the transmitter function button for more than 3 seconds, the indicator will flash for pairing, and wait for the transmitter indicator to be always on, indicating that the connection is successful.
- With one receiver and multiple transmitters, 1 receiver can pair with 8 transmitters for switching.
Function Settings
- Search for receiver in Wireless Network (Name is Hagibis-XXXX, default password is 12345678)
- Open the mobile / tablet browser and enter 192.168.203.1 in the address bar 3. After entering the website, you can operate the distribution network, resolution, upgrade and restart
Software Casting
When the receiver is used alone, it needs to cooperate with the software in
the mobile phone or computer
Complete the ‘Internet” distribution network in the Function Settings
Apple iOS System – Operation Steps
Slide the screen to enter the Apple Device Control Center, click Airplay, and
check the Hagibis device.
Android System – Operation Steps
- Turn on the screencasting function in the mobile phone/tablet
- Search and connect to Hagibis device
Different brand screen casting function path reference
HUAWEI: Setting>Smart Assist>Multi-screen Interactive
Xiaomi: Settings-Connect and Share-Cast Screen
VIVO: Settings-Other connection methods-Smart screen
OPPO: Settings-Other connection methods-Smart screen
MEIZU: Setting>Display›Projection Screen
Lenovo: Setting Disptay>Wireless Display
SAMSUNG: Phone From Top To Bottom>Smart View
Please contact service weChat formore models and brands
Problem-solving
Q: How to restore factory settings? A: When the product fails, press and hold
the receiver function button for 10 seconds. After a black screen appears and
restart, the factory settings will be restored.
Q: Can devices without HDMI interface be used? A: Yes, please use the device
with an HDMI interface converter.
Q: How to enter privacy mode? A: Tap the transmitter function button to
disconnect or reconnect.
Product Warranty
Warranty clauses
- The user should provide the corresponding purchase invoice for HAGIBIS products when a warranty is being asked. The product warranty card, shipping documents, and purchase contract will also be regarded as the warranty certificate.
- HAGIBIS will be responsible for the hardware faults of HAGIBIS products caused by the normal use during the warranty period.
- The warranty period starts from the date of purchase of the products or the receipt date of the logistics. The repaired products will continue to enjoy the warranty service during the warranty period. If the warranty period will end in less than three months, then the newly replaced parts will be guaranteed for three more months from the date of replacement.
- The faulty parts from the products will be owned by HAGIBIS, and the appropriate cost will be charged if necessary. If the products under maintenance have been updated and cannot be repaired, then the buyer can choose a refund.
- The warranty policy of HAGIBIS products accessories will vary according to the main products.
Non-warranty clauses
Neither of the following circumstances, even within the warranty period,
could have warranty services.
A. The user cannot provide the corresponding purchase invoice, product
warranty card, shipping documents, purchase contract, or other vouchers.
B. The faulty parts belong to the consumption materials, such as the shell,
the natural consumption wear and aging of the plug parts)
C. Faulty or damage caused by improper installation, operation, or use in an
abnormal environment, such as the temperature is too high or too low; too wet
or too dry; too high; the voltage or current is not stable; the zero to earth
voltage is too large, etc).
D. Faulty or damage caused by accident or by human ( including computer virus,
operation error, fluid entering, scratching, transportation, incorrect wiring,
insect damage, etc.); Faulty or damage caused by force majeure (such as
earthquake, fire, lightning, etc.).
E. Damage caused by self-repairment.
G. Other faculties or damages not caused by product design, technology,
manufacturing, quality, etc. H. Factory production test and operation, etc.
Special statement
Our company is not responsible (or any direct or indirect losses caused during
the usage of NAG1815 products normally ( including damage to user’s data
records or other tangible or intangible assets.
If any applicable law of the state has clear stipulations. our company shall
bear the responsibility according to the obligations stipulated by the state
law
After-sales information
Order number:
User ID: Contact number:
Product name:
After-sates problem
If you need to return Me goods. please contact custom& service to confirm the
return information. After the customer service confirms it, please fill in the
card and send it back together with the product.
Note: Our company reserves the right to explain and modify the warranty
card of this product within the scope of the law.
Operation Video
Artificial Customer Service
http://weixin.qq.com/r/Szm9pUXEyxi0rQHG92xZ
Fans Welfare
Product Trial
Email: support@hagibis.com
Website: http://wvwv.hagibis.com
Hotline: 400-820-6093 ( Working days
from 9:00AM to 6:00PM )
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF exposure guidelines, This equipment
should be installed and operated with a minimum distance of 20cm the radiator
your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>