FS S5500-48T8SP SNTP Configuration User Guide
- June 3, 2024
- FS
Table of Contents
FS S5500-48T8SP SNTP Configuration
Overview
Stipulations
Format Stipulation in the Command Line
| Syntax | Meaning |
|---|---|
| Bold | Stands for the keyword in the command line, which stays unchanged |
and must be entered without any modification. It is presented as a bold in the
command line.
{italic}| Stands for the parameter in the command line, which must be replaced
by the actual value. It must be presented by the italic in the brace.
SNTP Configuration
Overview
Simple Network Time Protocol (SNTP) is currently an important method to
realize time synchronization on the Internet. SNTP adopts the client-server
mode. The server obtains its own time by receiving the GPS signals or takes
its own atomic clock as its time standard, while the client, by regularly
accessing the time service provided by the server, gets the correct time
information and regulates its own clock to synchronize with the time on the
Internet. The UDP protocol and port 123 are used for communication between the
client and the server.
SNTP Configuration Task List
SNTP settings can be divided into two parts:
one part is for the local switch to take as the SNTP server, and the other is
for the local switch to take as the SNTP client.
The local switch takes as the SNTP server:
- Setting the Grade of the SNTP Server
- Enabling the SNTP Server
The local switch takes as the SNTP client:
- Setting the IP Address of the SNTP Server
- Setting the Interval of Browsing the SNTP Server
- Disabling the SNTP Server
SNTP Configuration
Setting the Grade of the SNTP Server
Configuration mode: Global
| Command | Purpose |
|---|---|
| sntp master [Stratum] | Sets the grade of the SNTP server. |
Enabling the SNTP Server
Configuration mode: Global
| Command | Purpose |
|---|---|
| sntp master | The SNTP server is enabled by default. |
Setting the IP Address of the SNTP Server
Configuration mode: Global
| Command | Purpose |
|---|---|
| sntp server <A.B.C.D> [sntp-version] | Sets the IP address and version of |
the SNTP server.
Setting the Interval of Browsing the SNTP Server
Configuration mode: Global
| Command | Purpose |
|---|---|
| sntp query-interval < minutes> | Sets the interval for the SNTP client to |
browse the SNTP server.
Disabling the SNTP Server
Configuration mode: Global
| Command | Purpose |
|---|---|
| no sntp master | Closes the SNTP server. |
https://www.fs.com.
The information in this document is subject to change without notice. FS has
made all efforts to ensure the accuracy of the information, but all
information in this document does not constitute any kind of warranty.
Copyright 0 2009-2022 FS.COM AII Rights Reserved.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>