ZEBRA Sidewinder Tube Replacement Instructions
- June 3, 2024
- ZEBRA
Table of Contents
ZEBRA Sidewinder Tube Replacement
TUBE REPLACEMENT INSTRUCTIONS
Step 1: To access the cartridge remove the base plate from the skimmer
unit using the 3 screws and washers mounted to the bottom of the unit.
Step 2: Replace the tube in the cartridge following the instruction
below.
For Model# ZVA8 (“G”)
-
. After removing the cartridge from the complete skimmer assembly, position it so the tube is facing you and the ceramic washer is on the left. Refer to Figure A.
• Circular markings on the inside of gears must be facing up.
-
Remove four flat head screws and separate cartridge halves. Do this with caution, as the interior of the cartridge contains grease.
-
Install new tube assembly as shown. Note the location of the ceramic scraper, positioning it so the raised writing is facing away from the cartridge.
-
Replace upper cartridge half. Refer to Figure B.
• Figure B. Once assembled the white ceramic scraper is on the right and the Zebra® logo will be visible
-
Refasten the cartridge by replacing the four screws from step 2b. Do not overtighten, using 9 in. lbs. only.
-
Hold the assembled cartridge in one hand while pulling the tube through. Refer to Figure C. This pull test will help to verify that the tube is seated correctly within the gear drive mechanism.
• Figure C. Confirm installation is correct by doing a pull test to verify tube is seated correctly. Note correct placement of white ceramic ring.
-
Reassemble the entire skimming unit. Refer to pictures below.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>