FS S3900-R Series Switch Reset and Recovery System User Guide
- June 3, 2024
- FS
Table of Contents
- FS S3900-R Series Switch Reset and Recovery System User Guide
- 1. Configuration Considerations
- 2. Network Topology
- 3. Operation Steps
- According to the way of networking topo to connect PC and switch to network
- After the connection is completed, there we recommend the super terminal,
- Energizing the switch, then open the installed login software, select the
- 3.4 Restoration System
- 3.5 Switch to Factory Reset
- Read More About This Manual & Download PDF:
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
FS S3900-R Series Switch Reset and Recovery System User Guide
1. Configuration Considerations
2. Network Topology
3. Operation Steps
1. Connection Equipment
According to the way of networking topo to connect PC and switch to network
cable and Console. One end of the RJ-45 network cableisconnected to the PC NIC, and the other end is connected to the SW’s network port. Connect one end of Console line USB toPC’s USBinterface, and the other end of RJ-45 is connected to console interface of front panel ofswitch.
2. Download Configuration Software
After the connection is completed, there we recommend the super terminal,
putty or Secure CRT tool to configure the switch
3. Switch on and Use Login Software
Energizing the switch, then open the installed login software, select the
serial port of login mode, port through the device manager todetermine. Baud rate :115200, Data bits: 8, Parity: None, Stop bits: 1. (Reference below)
NOTE: COM Number can be viewed through device manager. (right click on my computer.>manage>device manager>port (COMandLPT）If it displays an unrecognized USB device, please download and install the corresponding driver.
3.4 Restoration System
Please use Ctrl + P to enter the monitor # interface when restarting the switch,then configure the switch IP address. monitor#ip address 192.168.1.1 255.255.255.0 Set PC IP address
*Then prepare tftp
- Then start upgrading the system: run copy tftp flash
Monitor#copy tftp flash //From ftp to flash
Source file name[ ]? FS-S3900-48T6S-R-FSOS 2.2.0E 95660.bin //Firmware file name Remote-server ip address[ ]? 192.168.1.2 //TFTP Server IP address Destination file name[FS-S3900-48T6S-R-FSOS 2.2.0E 95660.bin]? //Switch.bin When prompted: TFTP: successfulfully sent… After the success # reboot justfine
3.5 Switch to Factory Reset
Switch#delete startup-config this file will be erased, are you sure? (y/n)y
Switch#reboo
If the file name is not entered, the startup-config files will be deleted by default
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>