maxcare MAX-Q01A06RG Nano Water Mist User Manual
- June 3, 2024
- maxcare
Table of Contents
maxcare MAX-Q01A06RG Nano Water Mist
Reminder
- Please fill with natural mineral water. If you want to add toner or essential oil, please add water to make a dilution according to the ratio of 1:9.
- Please shake it before use. Must need tighten cap after fill in the mineral water. Then turn on the Nano Water Mist for 1 minute. Dry the mist port with tissue when it was wet
Product introduction
Nano Water Mist is equipped with high-tech chip control, producing a finer mist that quickly enters the skin pores, reducing wrinkles, relieving skin irritation, and also promoting skin metabolism and improving skin pigmentation.
How to use
- Please press the power button to turn on the mist, and blue light indicates being in use. With the time memory function, the Nano Water Mist will automatically power off in 60 seconds.
- The skin without makeup is sprayed from about 10cm, and the makeup skin should be sprayed from around 15cm, which will not mess up your makeup.
- Please fill in the water from the port. (Please use mineral water)
How to charge:
- Pour out all the water, and install the cap.
- Please use the equipped cable to connect the USB port. (Android phone data cable can replace it)
- Please don’t use the Nano Water Mist when it was charging, extended battery life for better usability. And please charge for 3 hours when first time to use.
Cleaning and Maintenance
- Before cleaning, please make sure the switch has been turned off, and the power plug has been pulled out from socket.
- Please use a piece of clean and soft cotton cloth to clean this product. The cloth can be soaked in soap water first, but please dry it to damp before cleaning.
- Do not use corrosive cleaning agents like benzene or thinner to clean the product, otherwise, the color of product will fade, and the internal parts may be corrupted or broken.
- Please keep the product away from direct sunlight, or high temperature, to avoid fading.
- Please clean the water tank and store in a dry place if not in use for long.
FAQs and Solutions
| Issues | Solutions |
|---|---|
| Product not functioning | Battery is low, put on charge immediately. |
| Product was on but not functioning or the mist was small. | 1. The water tank |
was out of water, fill water into the water tank and restart the Nano Water Mist.
2. Battery is low, put on charge immediately.
3. Dry with tissue when there are leak in the mist port.
4. Clean the water tank when there are something clogged.
Product was leaks| Please screw the cap.
Technical Specifications
-
Product Name :Nano Water Mist
-
Product Model MAX-Q01A06RG
-
Rated Voltage :DC5V Rated Current :0.5A
-
Rated Power 1.5W
-
Battery 3.7V
-
Capacity 25ml
-
Gross Weight 95g
-
Product Size 37mm x 37mm x 146mm
Input Interface : Micro USB -
Material ABS+PC + Electronic
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>