STR GROUP STRMPSERIES Smart LED Projector Owner’s Manual
- June 12, 2024
- STR GROUP
Table of Contents
STR GROUP STRMPSERIES Smart LED Projector Owner’s Manual
Sound Settings
- Key Tone: On / Off
- Sound Effect: Standard/ Vivid
- Boot Sound: On / Off
Select language
Homepage>Settings>Language
System Settings
System upgrade:
- Online upgrade /U disk upgrade
- estore factory settings: Select restore factory settings (Be cautious)
- Device information:
Projector model/System version/ UI version/MCU version/ROM/RAM/Eth Mac.
Note: It is not recommended to upgrade built-in APP, which may cause
incompatibility problems.
Online Upgrade
- Homepage >Settings>System Settings>System Upgrade. Before you update please connect the power adapter and wifi, otherwise, the update will fail or the system will crash.
- If there is no reaction, please return to settings and try again,after finishing update, the system will turn on automatically.
- If it shows the lastest version of software then the system is up to date.
Switch to bluetooth speaker mode
- Turn on bluetooth function on the settings:
- Short press power button on remote control or long press on/off button of machine, select the bluetooth speaker mode then you can start the bluetooth pair and connection to use;
- If you want to stop the Bluetooth speaker ,press power button on remote control or on/off button of machine to wake up the projector, and quit the bluetooth connection automatically.
ATTENTION
For some high version apps, you need to use the mouse to perform comprehensive
and fast operations, such as Netflix and YouTube…etc.
FCC Warning
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part15of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>