SAMLEX EUROPE BSW 160 Dual Intelligent Battery Separator Owner’s Manual

BATTERY SEPARATOR
Intelligent Battery Separator
Model No. BSW 160 DUAL BS 500 DUAL
OWNER’S MANUAL

Please read this manual before operating your separator

Installation and user’s manual

Description:

The BS microprocessor controlled battery separator is used in multi- batteries systems like on boats, RV, service vans. It supervises the primary battery state of charge and therefore avoids starting problems. The BS can also be used as a voltage dependent switch. The working principle is the following: the BS lets the primary battery being recharged by the alternator until a voltage of 13.2V (26.4V) during at least 7 seconds is reached. Then the two batteries are put in parallel by the contact of the relay. The secondary users are normally connected to the auxiliary battery. The relay opens when the batteries voltage reaches 12.8V (25.6V) during at least 60 seconds. This way the starter battery remains charged. If a battery charger is connected to the auxiliary battery and this battery reaches a voltage of 13.2V (26.4V) during at least 7 seconds, the relay closes and charges at the same time the starter battery. This is an advantage if the vehicle remains stationary over a long period of time. If the battery charger is disconnected and the battery voltage reaches 12.8V (25.6V) during at least 60 seconds, then the BS separates again the two batteries

Start assistance:

The BS has an additional connection enabling an assistance to the starting. If the connection STATUS is connected to the starter contact, the BS contact closes and this way the 2 batteries contribute to the engine start. Cautious when this function is used very high currents may go through the relay contact by the start of big engines. These high currents may damage the contact of the BS if they exceed its nominal current.

Voltage dependent switch:

In some cases it is needed to have a powerful DC source supply but only when the engine is running. The BS allows also this kind of installations. It is sufficient to simply connect + the primairy battery to the connection A1, the system earth to the connection MINUS and the positive of the equipment to supply to the connection A2. When the engine runs a voltage of 13,2V (26,4V) during at least 7 seconds is reached, the equipment is then powered thru the contact of the BS.

Protection against over voltages:

The BS has also a function enabling to protect the battery and the appliances that are connected to it against an overvoltage generated, for instance, by a defectuous alternator. As soon as a voltage higher than 16 V (32V) is detected, the contact of the BS opens immediately.
Installation: To implement the function «start assistance», a fuse protected connection has to be carried out between the connection STATUS and the contact of the startercontact.

A short-circuit between the positive and negative of the batteries can damage your system. Make sure that the connections are properly done!

Technical specifications:

24V=170mA (160A) 100mA (500A)
Minimum chargetime:|  60 seconds
Fast opening:| < 11.8V (12V) / 23.6 (24V) after 4 seconds

Connections:

dependent switch» is needed, connect the equipment positive here)
STATUS:| 1) Contact to +, relay is closed (Startassistance)
2) No connection on STATUS, normal operation
3) Contact to -, relay remains clossed
MINUS:| Negative terminal: (Cautious this connection must
always remain connected via a fuse of 3A)
LED:| Connection for remote reading of status BS)

www.samlex.com
www.samlex-solar.com

References

• Samlex Europe manufactures and distributes power conversion products to more than 90 countries worldwide.
• Samlex Europe manufactures and distributes power conversion products to more than 90 countries worldwide.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>