RYOBI RHMS4101 Heavy Duty 4 in 1 Manual Stapler Instruction Manual
- June 3, 2024
- RYOBI
Table of Contents
RYOBI RHMS4101 Heavy Duty 4 in 1 Manual Stapler
WARNING:
Do not allow familiarity with this product to make you careless. Remember that
a careless fraction of a second is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to comply with ANSI Z87.1.
Failure to do so could result in objects being thrown into your eyes and other
possible serious injuries.
UNLOCKING THE TOOL
WARNING:
Always unload the unused fasteners before locking the lever when taking a
break from your project or storing the tool. Failure to follow this rule could
result in accidental discharge and cause personal injury
The tool ships with the lever in the locked position.
- To unlock, rotate the lock knob clockwise to release the lever.
- To lock, empty the fasteners, squeeze the lever, and rotate the lock knob counterclockwise.
NOTE : Always remove the fasteners before locking the lever.
LOADING THE TOOL WITH FASTENERS
WARNING:
Use only the fasteners recommended for use with this tool. The use of any
other fasteners can result in tool malfunction, leading to serious injuries.
WARNING:
Keep the tool pointed away from yourself and others when loading fasteners.
Failure to do so could result in possible serious personal injury.
This tool can use several types of fasteners including crown staples and brads.
-
Hold the tool on its side with the driving end of the tool facing to your left as shown.
-
Squeeze the magazine release button located at the rear of the magazine and slide the magazine cover open.
-
Place fasteners in the channel with the tips pointing upward and the crown resting on the bottom of the channel.
NOTE : Be sure to align the fasteners to the lower side of the magazine as directed by the arrow that is shown on the magazine’s cover. -
Push the magazine cover closed. Make sure it securely locks into place.
ADJUSTING DEPTH OF DRIVE
The driving depth of the fastener is adjustable. It is advisable to test the
depth on a scrap workpiece to determine the required depth for the
application.
To determine depth of drive, drive a test fastener. Harder materials and
longer fasteners will require more force to drive the fastener.
- Raise or lower the depth of drive adjustment to the more (+) or less (–) setting.
- Drive a test fastener after adjusting to be certain the desired depth is set.
-
Lock knob
-
Lever
-
Belt hook
-
Depth of drive
-
Magazine release
-
Fasteners
-
Arrow
-
Magazine
-
Latch
-
Reload indicator
TTI CONSUMER POWER TOOLS, INC. P.O. Box 1288, Anderson, SC 29622 Phone
1-800-525-2579
www.ryobitools.com