VULCAN DIY Bicycle Repair Stand User Manual
- June 3, 2024
- Vulcan
Table of Contents
DIY BICYCLE REPAIR STAND
USERS MANUAL
Read these instructions through carefully before using this product for the first time and afterwards retain them for future reference!
TECHNICAL SPECIFICATIONS:
Maximum load: 30 kg
For bicycle frames size 25 mm – 40 mm
INTENDED USE:
This bicycle assembly stand was developed for private use.
CONTENTS:
1 x allen key
1 x tripod (A)
1 x telescopic pole (B)
1 x bicycle bracket (C)
1 X tool tray (D)
1 X instructions
ASSEMBLY:
Set up the tripod of the bicycle assembly stand by sliding the coupling (1) on
the tripod (A) all the way down.
Fold the feet (2) on the tripod legs down and ensure the product is placed on
a solid and even surface.
Now insert the telescopic pole (B) into the tripod, then mount the bicycle
bracket (C) onto the telescopic pole. The tool tray (D) can be attached
anywhere on tripod (A).
Note
The feet on the assembly stand may optionally be screwed into the surface to
achieve greater stability. Be sure to use the suitable mounting materials.
ATTACHING THE BICYCLE:
Attention:
After inserting the bicycle verify it is securely positioned and the bicycle
assembly stand is stable.
Please observe the maximum extension lengths of the telescopic rod (B) Never
extend the cross-bar on the bicycle bracket (C) further than shown in fig.1.
Select a section of the bicycle frame to be clamped into the bicycle assembly
stand.
This frame section must be at the bicycle’s centre of gravity.
Adjust the angle of the bicycle bracket (C) to fit the selected frame position
of the bicycle (see examples in fig. 2 and fig. 3) and tighten the screw (3)
(fig.4). Now place the
bicycle in the bicycle bracket and firmly secure frame. Firmly tighten the
screw (4) (fig.4).
We recommend performing the next step (height adjustment) with 2 persons.
You may then extend the telescopic rod (B) to the desired height.
Twisting the telescopic rod allows you to also change the position of the
attached bicycle.
Once you have reached the desired height and position firmly tighten the screw
(5) (fig. 3).
TOOL TRAY:
A magnet is located inside the large compartment of the tool tray for securing
small parts.
MAINTENANCE AND STORAGE:
Routinely clean the bicycle assembly stand. Always follow with a dry cloth!
Avoid harsh chemicals (e.g. solvents)!
Store the product in a dry and well-ventilated area.
Exclusively Distributed By
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>