zencontrol zc-smart-relay Inline Relay Instructions

: June 3, 2024
: zencontrol

Table of Contents

zencontrol zc-smart-relay Inline Relay
Product range
Specifications
Safety information
Installation
- Wiring diagram
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

zencontrol zc-smart-relay Inline Relay

zencontrol zc-smart-relay Inline R product

Product range

Order code Description
zc-smart-relay Wired / wireless relay controller, field mount

Specifications

Supply voltage 230 V ~ 50 Hz
Control system Wired DALI-2 Wireless IEC62386-104 over Thread
Radio support IEEE 802.15.4
Frequency band 2.4 GHz
Max radio tx power +8 dBm
DALI line current 2 mA
Output load 10 A resistive 6 A inductive
Output type Switched 240V~ active
Max. in-rush 165 A 20ms 492 A 1.5ms
Min. rated relay operations 40 000
Contact rating 100mΩ max. (at 1A 6V dc)
Max. operations per hour 360
Relay type Non-latching normally open
Wiring 1 – 4 mm2 Strip 6 – 7 mm
Operating temperature 0 to 55°C
Material PC
Classification Class II
Ingress protection IP20

Safety information

This product must only be installed by a licensed electrician.
Before commencing installation turn off and isolate the electrical supply.
There are no user serviceable parts, attempting to service any part of the product will void the warranty
DALI is not SELV and as such should be treated as LV.
As the installer, it is your responsibility to ensure you comply to all relevant building and safety codes. Refer to application standards for the relevant rules.

Dimensions

Mounting options Independently mounted control for surface mounting
Fixing centres 125 mm
Dimensions 148 / 44.5 / 30 mm

Installation

Remove the product from the box and inspect it for any damage. If you believe the product to be damaged or otherwise unsound, do not install the product. Please pack it back into its box and return it to the place of purchase for replacement.
If the product is satisfactory, proceed with the installation:

Ensure safety warnings are adhered to.
Release the two end covers using a flatblade screwdriver.
Mount driver, and wire the as per the wiring diagram in
Replace end covers to ensure adequate strain relief.

Note relay must have an appropriate MCB to protect the load circuit.

Wiring diagram

Wire preparation

104 mode is enabled after the device has been added to a 104 application controller such as zc-iot-fc.
Wireless relay
IEC 62386-208
104 + 101 Bridge mode is enabled after the device has been added to a 104 controller and a 101 power supply has been connected to the DALI terminals.
101 mode is enabled after a 101 power supply has been connected to the DALI terminal and the device has not been added to a 104 application controller.