HYGIPLAS GH628 Water Resistant Digital Thermometer Instruction Manual

: June 3, 2024
: HYGIPLAS

Table of Contents

HYGIPLAS GH628 Water Resistant Digital Thermometer
Features
Specification
Operation
Symbols
Compliance
WARNING
Read User Manual Online (PDF format)
Download This Manual (PDF format)

HYGIPLAS GH628 Water Resistant Digital Thermometer

Features

IP65 water resistant
Selectable temperature units, °C or °F.
Data hold function
Maximum and minimum reading memory
Stainless steel probe

Specification

Temperature range	-50 to 200°C / -58 to 392°F
Display Accuracy	±1°C between -19.9°C to 119.9°C /

±1.8°F between -3.8°F to 247.8°F

Operation

Power ON/OFF

Press [ON-OFF] to turn on.
Press and hold for approximately 3 seconds to turn off.

Select Temperature Unit
Press and hold [°C/°F] for 3 seconds and release to change the temperature unit.
Data Hold

Press the [HOLD] button once to retain display reading and the°C or °F icon will be flashing.
Press the button again will release the hold function and return to normal display.

Maximum/Minimum Reading Memory

Press the [MAX/MIN] to display maximum reading.
Press the button again to display minimum reading.
Press the button once more to display normally.
To reset the memory, switch the thermometer off then on.

Reset the memory once before taking new readings.

NOTE:

Clean the probe immediately after each measurement to avoid cross contamination.
When replacing battery, ensure all screws are tighten fully, otherwise it will affect the water resistant function.
When the display becomes dim replace the battery.
If there is any abnormal display or operation, switch off the unit once. All user settings will be reset to ex-factory settings.

Symbols

Symbol	Description	Action required
LLL.L	1. Sensor open circuit

2. The reading is out of lower limit (-50°C)

| 1. Return the thermometer for repair

2. Keep the measurement above lower limit

HHH.H| 1. Sensor short circuit

2. The reading is out of upper limit (200°C)

| 1. Return the thermometer for repair

2. Keep the measurement below upper limit

Compliance

Dispose of depleted batteries in accordance with local regulations, within the EC there are nominated disposal points for batteries. The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area. HYGIPLAS parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities. HYGIPLAS products have been approved to carry the following symbol:

WARNING

KEEP OUT OF REACH OF CHILDREN
Swallowing can lead to chemical burns, perforation of soft tissue, and death Severe burns can occur within 2 hours of ingestion. Seek medical attention immediately.

All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of HYGIPLAS. Every effort is made to ensure all details are correct at the time of going to press, however, HYGIPLAS reserve the right to change specifications without notice.