QUAKE GLOBAL HPRO-4GV2 Mobile Terminal Installation Guide
- June 3, 2024
- QUAKE GLOBAL
Table of Contents
QUAKE GLOBAL HPRO-4GV2 Mobile Terminal
SUBJECT
Instructions for installing the mobile terminal (HPRO) to the CABc
OUTLINE
To install the mobile terminal to the machine, follow the mobile terminal installation.
Removing the rear cover
- Remove the caps
- Remove the bolts and screws
- Remove in the following order: left and right covers (no specific order), upper cover and then, bottom cover. Work carefully with the lighter harness.
Installing the mobile terminal
- Routing of GPS harness and installation of bracket
- Installation of mobile terminal
Safety Warnings and Hazards
Read this section in its entirety before operating the Quake Global HPRO.
FederalCommunications Commission statement
HPRO complies with Part 15 of the Federal Communications Commission (FCC) rules for a Class A device. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with this guide,may cause harmful interference to radio communications. Operation of this equipment ina residential area is likely to cause harmful interference in which case the user will be required to correct the interference at their own expense. Changes or modifications made to the HPRO device not expressly approved by Quake Global could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- this device must accept any interference received, including interference that may cause undesired operation.
Industry Canada statement
HPRO complies with Industry Canada ICES-003 Class A specifications. HPRO contains license-exempt transmitters or receivers that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSSs. Operation is subject to the following two conditions:
- This devicemay not cause interference.
- This devicemust accept any interference, including interference thatmay cause undesiredoperation of the device.
HPRO operation is restricted to the indoor use for the frequency band 5150 – 5250MHz. The PMN is HPRO.
RF Exposure Notice
THIS DEVICE MEETS THE GOVERNMENT REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.
HPRO is a radio transmitter and receiver. It is designed andmanufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government and Industry Canada.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>