RYOBI A99HPR1 Hinge Pin Remover-Installer User Manual
- June 3, 2024
- RYOBI
Table of Contents
RYOBI A99HPR1 Hinge Pin Remover-Installer
WARNING:
To reduce the risk of injury, do not attempt to use this product until you
have read thoroughly and understand completely this operator’s manual. Ensure
compatibility and fit before using this accessory. Do not use this accessory
if a part is damaged or missing.
REMOVING/INSTALLING HINGE PINS
A typical door hinge has two interlocking hinge plates secured together by a hinge pin. Use this product to install or remove the hinge pin.
To remove a hinge pin:
-
With the punch facing up, slide the product onto the base of the hinge until the punch contacts the bottom of the hinge pin (see figures 1 and 3).
NOTE: If the hinge pin does not extend past the base of the hinge, insert the punch into the hinge until it contacts the pin. -
Using a hammer, forcefully tap the strike plate until the punch pushes the head of the pin out of the hinge.
-
Slide the product down so that the punch is no longer inside the hinge.
-
Hold the product at an angle with the tip under the head of the hinge pin (see figure 4).
-
Continue tapping the strike plate until the pin is completely removed from the hinge.
NOTE: Be careful. The door could move unexpectedly after the pin is removed.
To install a hinge pin:
- Align the interlocking parts of the hinge plates.
- Slide the hinge pin into the hinge plates until resistance is felt.
- With the punch facing down, slide the product onto the top of the hinge until the contact surface is touching the head of the hinge pin (see figures 1 and 5).
- Using a hammer, forcefully tap the strike plate until the contact surface pushes the pin inside of the hinge.
NOTE: Ensure the pin is flush with the top of the hinge before attempting to open and close the door.
TTI CONSUMER POWER TOOLS, INC.
P.O. Box 1288, Anderson, SC 29622
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>