Bestway 56283 Steel Pro Pool Owner’s Manual

Bestway 56283 Steel Pro Pool Owner’s Manual

Refer to the item name or number stated on the packaging.
Packaging must be read carefully and kept for future reference.

WARNING

Never leave your child unattended – drowning hazard.

• Only for domestic use.
• Only for outdoor use.
• Children can drown in very small amounts of water. Empty the pool when not in use.
• Do not install the paddling pool over concrete, asphalt or any other hard surface.
• Place the product on a level surface at least 2 m from any structure or obstruction such as a fence, garage, house, overhanging branches, laundry lines or electrical wires.
• Recommend back towards the sun when playing.
• Modification by the consumer of the original paddling pool (for example the addition of accessories) shall be carried out according to the instructions of the manufacturer.
• Keep assembly and installation instruction for future reference.

PARTS

STRUCTURE PHOTO

Drawings may not reflect actual product, not scaled to size.

Ref

| Description| Quantity
---|---|---
A| Top Rail|

6

B

| Vertical Pool Leg| 6
C| Connector|

6

D

| Bolt| 6
E| Footing|

6

PREPARATION

A single-handed installation of a small swimming pool usually takes only 10
minutes. Recommendations regarding placement of the pool:

• It is essential for the pool to be set up on solid, leveled ground. If the pool is set up on uneven ground it can result in collapse and flooding, causing serious personal injury and/or damage to personal property.
• Do not set up on driveways, decks, platforms, gravel or asphalt. Ground should be firm enough to withstand water pressure; mud, sand, soft / loose soil or tar are not suitable.
• Ground must be cleared of all objects and debris including stones and twigs.
• Check with your local city council for by-laws relating to fencing, barriers, lighting and safety requirements and ensure you comply with all laws.

INSTALLATION

Assembly can be completed without tools.

NOTE: It is important to assemble pool in the order shown below. Adult assembly required.

1. Take the pool and accessories out of the carton with care. Spread the pool out onto the selected site.

2. Close the water valve.

3. Insert all the Top Rails into the pole sleeve on the top of the pool. (Fig.1) Please see the structure photo for detailed directions.

4. Insert both ends of Top Rails into the Connector. Then insert Bolt into the top of the Connector. (Fig.2) Repeat this procedure for remaining parts. (Fig.3)

NOTE: In each Connector, ensure both Top Rails are properly inserted.

5. Attach all Footings to the bottom of the Vertical Pool Legs. Then insert the Vertical Pool Legs into the bottom of the Connectors. (Fig.4)

6. Test frame to ensure all connections are secure before filling with water. (Fig.5)

7. Add 1’’ (2 cm) of water into the pool to cover floor. Once pool floor is slightly covered, gently smooth out all wrinkles. Start at the center of the pool and work your way clockwise to the outside.

8. Coutinue to fill the pool until the water reaches the welding line located 3cm-8cm (1.2”-3.1”) from the top of the pool. Please kindly pay the upmost attention to not over fill the pool for security reasons.
   

DISMANTLING

1. Open water valve on the bottom of the pool, water will drain automatically. (Check local regulations for drainage by-laws). Then dismantle pool frame to release water. Make sure you release most of the water within 20 minutes.
   NOTE: Only adults should drain the pool!

2. Air dry the pool.
   ATTENTION: Do not leave the drained pool outside.

REPAIR

If your pool is damaged, use the provided repair patch.

1. Clean area to be repaired.
2. Carefully peel patch.
3. Press patch over area to be repaired.
4. Wait 30 minutes before inflation.

POOL MAINTENANCE

WARNING: If you do not adhere to the maintenance guidelines covered here in, your health might be at risk, especially that of your children.

• Change the pool water frequently (particularly in hot weather) or when noticeably contaminated, unclean water is harmful for the users.

• Please contact your local retailer for chemicals to treat water in your pool.
  Be sure to follow the chemical manufacturer’s instructions.

• Proper maintenance can maximize your pool’s lifespan.

• See packaging for water capacity.

CLEANING AND STORAGE

1. After use, clean surfaces gently with a damp cloth.
   NOTE: Never use solvents or other chemicals that may damage the product.

2. Remove all accessories and spare parts of the pool, clean and dry them.

3. Once pool is completely dry, sprinkle with talcum powder to prevent the pool from sticking together and fold the pool carefully. If pool is not completely dry, mould may develop, which will damage the pool liner.

4. Store liner and accessories in a cool, dry place out of children’s reach, with a moderate temperature between 5°C / 41°F and 38°C / 100°F.

5. During rainy season, pool and accessories should be stored as instructed above.

6. Improper draining of the pool might cause serious personal injury and/or damage to personal property.

7. Check the product for damage at the beginning of each season and at regular intervals when in use.

SUPPORT

©2021 Bestway Inflatables & Material Corp.
Bestway Inflatables & Material Corp., Shanghai, China
Bestway (Europe) S.r.l., Via Resistenza, 5, 20098 San Giuliano Milanese (Milano), Italy
Bestway Central & South America Ltda, Salar Ascotan 1282, Parque Enea, Pudahuel, Santiago, Chile
Distributed in Australia & New Zealand by Bestway Australia Pty Ltd, Unit 2/98-104 Carnarvon St Silverwater, NSW 2128, Australia
Tel: Australia: (+61) 29 0371 388; New Zealand: 0800 142 101

Exported by : Bestway (Hong Kong) International Ltd./Bestway Enterprise Company Limited Suite 713, 7/Floor, East Wing, Tsim Sha Tsui Centre, 66 Mody Road, Kowloon, Hong Kong
Tel: +86 21 69135588 (For U.S. and Canada)
www.bestwaycorp.com

References

• Home Page

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>