toPARC Arc Welding, Battery Chargers & Body Repair Instruction Manual

toPARC Arc Welding, Battery Chargers & Body Repair Instruction Manual

WARNINGS – SAFETY RULES

These instructions must be read and understood before any operation. Any modification or maintenance not indicated in the manual must not be undertaken.

The manufacturer shall not be held liable for any personal injury or material damage caused by use not in accordance with the instructions in this manual. In the event of a problem or uncertainty, consult a qualified person to handle the installation correctly. This manual describes the wiring of this product. Any user who does not strictly comply with the safety instructions described in this manual may be exposed to electrical risks and/or a serious or even fatal accident

ELECTRIC SAFETY

During any intervention on the product, make sure to secure the area by keeping at a distance any person who has not read the instructions of safety described in this manual. This product should preferably be installed by a professional in accordance with the installation rules in force in the country. If not, it is recommended that you read these rules before working on it.

PRECAUTIONS AGAINST ELECTROSTATIC DAMAGE

Static electricity can damage electronic equipment. Use a grounded anti-static wrist strap, an ankle strap, or equivalent safety device to prevent electrostatic damage (ESD) when installing this product.

INSTALLATION

The installation of the kit must be done with a case disconnected from the generator

1. Open the case

2. Remove the light grey cover by unscrewing the 6 Torx® screws.

   ---

3. Remove the plastic cap* next to the wire feeder

4. Pass the wiring harness through the hole and lock the cable gland by means of its nut.

5. Pull back the clips on the white wires of the 4-pin connector. (adjust the length of the beam if necessary)

6. Tighten the gland ring to lock the bundle.

7. Put the light grey cover back into position and screw it on.

• If the cap is not present on your product, it is necessary to make a hole.
  
  Ø 13 mm at the intended location :
  Do not drill too deep!

WARRANTY

The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).

The warranty does not cover:

• Transit damage.

• Normal wear of parts (eg. : cables, clamps, etc..).

• Damages due to misuse (power supply error, dropping of equipment, disassembling).

• Environment related failures (pollution, rust, dust).
  In case of failure, return the unit to your distributor together with:

• The proof of purchase (receipt etc …)

• A description of the fault reported.

SYMBOLS

• Device complies with europeans directives. The EU declaration of conformity is available on our website (see cover page).

• Equipment in compliance with British requirements. The British Declaration of Conformity is available on our website (see home page).

• This hardware is subject to waste collection according to the European directives 2012/19/EU. Do not throw out in a domestic bin!.

• This product should be recycled appropriately.

JBDC
1, rue de la Croix des Landes – CS 54159
53941 SAINT-BERTHEVIN Cedex
FRANCE

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>