NATIONAL GEOGRAPHIC 9060100 89W Mobile Power Station Instruction Manual
- June 3, 2024
- NATIONAL GEOGRAPHIC
Table of Contents
NATIONAL GEOGRAPHIC 9060100 89W Mobile Power Station
Visit our website via the following QR Code or web link to find further information on this product or the available translations of these instructions.
MANUAL DOWNLOAD:
About this Instruction Manual
Please read the safety instructions and the operating instructions carefully
before use. Keep these instructions for renewed use at a later date. When the
device is sold or given to someone else, the instruction manual must be
provided to the new owner/ user of the product.
General Warning
DANGER!
Children should only use the device under adult supervision. Keep packaging
material, like plastic bags and rubber bands, out of the reach of children, as
these materials pose a choking hazard.
Do not expose the device to high temperatures. Excessive heat or improper handling could trigger a short circuit, a fire or an explosion.
FIE RISK!
Do not place the device, particularly the lenses, in direct sunlight. The
concentration of light could cause a fire.
RISK of ELECTRIC SHOCK!
This device contains electronic components that operate via a power source.
Children should only use the device under adult supervision. Only use the
device as described in the manual; otherwise, you run the risk of an electric
shock.
NOTE!
Do not dismantle the device. In the event of a defect, please contact your
dealer. The dealer will contact the Service Centre and can send the device in
to be repaired, if necessary.
NOTES on Cleaning
Before cleaning the device, disconnect it from the power supply! Only use a
dry cloth to clean the exterior of the device. To avoid damaging the
electronics, do not use any cleaning fluid. Clean the eyepieces and/or lenses
only with a soft, lint-free cloth, (e.g. microfibre cloth). To avoid
scratching the lenses, use only gentle pressure with the cleaning cloth.
Protect the device from dust and moisture.
The unit provides Modified Sine Wave output
The unit provides Modified Sine Wave output, and can be compatible with AC
electric appliances that work with Sinusoidal waveform (power <80W). However,
anything that uses an AC motor isn‘t going to work to full capacity on a
modified sine wave, such as an electrical fan. It will even make the electric
appliance emit some noise. Appliances like refrigerators, microwave ovens, and
compressors that use AC motors and some delicate medical equipment will be
better off with a pure sine wave inverter. This product is only used for an
emergency, it cannot replace the normal alternating current, for long-term
use.
EC DECLARATION OF CONFORMITY
Bresser GmbH has issued a „Declaration of Conformity“ in accordance with
applicable guidelines and corresponding standards. The full text of the EU
declaration of conformity is available at the following internet address:
www.bresser.de/download/9060100/CE/9060100_CE.pdf
UKCA DECLARATION OF CONFORMITY
Bresser GmbH has issued a „Declaration of Conformity“ in accordance with
applicable guidelines and corresponding standards. The full text of the UKCA
declaration of conformity is available at the following internet address:
www.bresser.de/download/9060100/UKCA/9060100_UKCA.pdf
Bresser UK Ltd. • Suite 3G, Eden House, Enterprise Way • Edenbridge, Kent TN8
6HF, Great Britain
Scope of delivery
Mobile Power Station, Power Adapter, Micro USB cable
Technical data
-
Capacity 88.8wh,6Ah/14.8V (equivalent:24000mAh/3.7V)
-
Dimensions(LWH) 165x80x117 mm
-
Weight about 1.04 kg
-
Built-in Battery High-Quality Lithium-ion Batteries
-
Input Recharging Adapter: DC19V/1.5A
-
Solar Panel Charging: DC 15V-24V/1.2A Max
-
Time until fully charged DC19V/1.5A: 5~6 hours
-
USB Output 2 x USB 5V-2.4A Total:4.8A Max 2 x USB 5-12V/2A QC3.0(18W Max, Total: 5V/3.4A max) 1 x USB C 5V/3A,9V/2A,12V/1.5A(PD2.0 18W Max)
-
DC Output DC Output 12-16.8V/10A Total 13A Max
-
AC Output Modified SineWave Output; AC Voltage: 100/110/120/220/230/240VAC±10%
Output Frequency: 50/60Hz±10% Attention: Actual AC voltage/Frequency/Outlet(s) are customised according to different countries and areas. -
AC Power AC Continuous Output: 80W/120W Max
-
Bulb Type 1 x LED light
-
(low: 52 lm, medium: 92 lm, high: 132 lm, SOS)
-
Power Indicator LED Indicators
-
Operation temperature -10° – 40°
-
Lifecycle >500 times
Parts overview
- AC ON/OFF
- AC INDICATOR
- BATTERY INDICATOR
- POWER SWITCH
- LED LIGHT SWITCH
- AC Outlet
- USB: 5-12V/2A 18W Max Qualcomm QuickCharge 3.0 (Total 5V/3.4A Max)
- USB: 5V-2.4A Total:4.8A Max
- DC Output: 12-16.8V/10A (13A Max)
- USB-C: 5V/3A,9V/2A,12V/1.5A (PD2.0 18W Max)
PRODUCT INSTRUCTIONS
How to provide power for DC12V appliances (such as a head lamp or fan) with
this product?
Plug your appliances to the DC output port and press the power switch button
to gain power. DC output rated Current: 10A, Max output Current<13A.
Notices: Please confirm whether your DC12V appliance support charging with
5.5mm DC header interface (The diametre of the DC Port of the Product is:
5.5mm/2.1mm), otherwise it is unable to connect with the DC output, you can
consult the electrical manufacturer, buy the corresponding adapter and connect
with it.
WARNING!
Note: The DC output voltage has a range between 12V~16.8V, the maximum output
current is 13A. DC output voltage drops or increases while battery the
capacity drops or increases due to the chemical characteristics of the
battery. If your appliance does not have a built-in input voltage stabilizing
function, it may shut down when the input voltage is too low or too high. If
your 12V devices cannot work due to the input voltage being too high, please
read the device manual or consult the device manufacturer to get the input
voltage range of your device.
Protection Mode:
Short circuit/Overpower Protection: If the DC output is short-circuited or
overpowered (Load(s) power>150W), the unit will shutdown to protect itself.
Please resolve the problem and press the power button of the unit to exit from
the protection mode.
How to provide power for AC appliances with this product?
Connect the power cable plug of the electrical appliance to the AC outlet of
the product, long press the AC power button for 3-5 seconds to turn on AC
output, and the unit will start providing power to your appliance.
Limited Appliance Wattage<80W, Lamp, Electric Fan, TV, etc. AC will shutdown
when it’s short circuited or power overloaded. Remove the device and the unit
will recover from short-circuit or overpower protection in a few seconds.
Repress the AC output button to switch on AC output again When the AC port is
not in use, turn it off to conserve power.
ATTENTION!: AC Outlets, AC output voltage and frequency will be different
according to different countries or areas. Please refer to the actual product
before using.
Protection Mode:
Short-circuit/Overpower Protection: If the AC output is short circuited or
overpowered (Load(s) power>80W), the unit will shutdown AC output to protect
itself. Please resolve the problem and re-press the AC button for AC output.
Some devices, such as a refrigerator, an ice maker or a laser printer may
require a surge power to start or work during a very short time period, the
surge power could exceed 120W or even higher, this could cause overpower
protection with this unit. Please remove the devices and consult with the
device manufacturers for more information. Please resolve the problem and re-
press the AC button for AC output.
How to provide power for USB-C digital appliances with this product?
Connect the standard USB cable of the digital appliance to the USB output of
the unit, press the “ ” to turn on USB output. Notice: Some smart devices,
such as Bluetooth headphones and LED lights. Require very small input current
to charge, which could be less than 150mA. The unit may fail to charge these
kind of smart devices due to detection current limitation by the USB output
ports. On this occasion, the user can press the AC button “ ” to keep the USB
port output running. Please turn off AC output – when the smart devices are
fully charged – to save power.
Quick Charge Output: This product supports Qualcomm Quick Charge 3.0 and
USB C PD (Power Delivery)
2.0 Output, support: 5V/3A,9V/2A,12V / 1.5A 18W max output for smart devices
which also support Qualcomm Quick Charge 3.0 or USB PD2.0 Protocol. The actual
output voltage and current depends on the individual smart devices, it can be
obtained by consulting the smart device manufacturer.
LED light
This unit is built with ultra-bright LED light. It supports 3 levels of
brightness and SOS mode. Long press the button “ ” for 3 seconds to switch on
the LED light and single press the button to switch the higher brightness/SOS
mode/off.
Warning! Do not point directly at the eyes of humans in case of any
damage due to the strong light.
How to charge the unit?
-
Charge through the AC Wall Charger
Using the included AC Wall Charger, plug the unit into any wall outlet to charge the unit. You will know the unit is charging when the blue LED battery indicators are blinking. The unit is fully charged when all battery indicators stop blinking and remain solid. After the unit is fully charged, please remove the AC wall charger in time.
-
Charge from Solar panel
- Place your solar panel where it will get as much direct sunlight as possible.
- Plug the output of the solar panel into the input of the unit to start charging. You will know the unit is charging when the blue LED Battery Indicator lights up and blinks. The unit is fully charged when all battery indicators stop blinking and remain solid.
SECURITY AND MAINTENANCE
- Do not short-circuit the unit. To avoid short-circuiting, keep the unit away from all metal objects (e.g. coins, hair-pins, keys, etc.).
- Do not heat the unit, or dispose of it in fire, water or other liquids. Keep away from high temperatures. Do not expose the unit to direct sunlight.
- Keep away from high humidity, dusty places.
- Do not disassemble or reassemble this unit.
- In order to extend the life of the unit (lithium battery), do not drop, place heavy objects on, or allow any strong impact to this unit.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance. Do not cover the device with towels, clothing or other items.
- The unit may become hot when charging. This is normal. Use caution when handling.
- Do not charge the unit over the required time.
- Disconnect the unit when fully charged.
- Use the unit properly to avoid electronic shock.
- Please deal with scrap products in accordance with the regulations, do not treat the built-in battery as household garbage, so as not to cause an explosion and pollution
- The product is only used for emergency situations, it cannot replace the standard DC or AC power of household appliances or digital products.
PRODUCT APPLICATION
- This product consists of a high-quality lithium-ion battery, has no memory effect but a high capacity and is long-lasting. Nevertheless, we recommend that you use it in the range of 10 °C~30°C to maintain optimum charging capacity.
- When charging, in order to avoid interference, please remain away from TV, radio and other equipment.
- If the unit is not being used for a long time, please disconnect the cable and store it.
- Some portable devices may need to be set in charge mode to charge, see the corresponding equipment use manual for more information.
- In order to extend the life of the lithium battery it is best to charge within 3 months, and charge at least once within 6 months.
COLD WEATHER USAGE
Cold temperatures (below freezing) can affect the unit’s battery capacity due
to chemical characteristics of the battery. If you are living off-grid in sub-
zero conditions, we recommend you keep your unit in an insulated cooler, and
connected to a power source (solar panels). The natural heat generated by the
unit contained in an insulated cooler will keep battery capacity at its
highest.
BATTERY INFORMATION
Your device has an internal, non-removable, rechargeable battery. Do not
attempt to remove the battery, as you may damage the device. The battery can
be charged and discharged over 500 times, but it will eventually wear out.
NOTES ON CLEANING
Before cleaning the device, disconnect it from the power supply (remove plug)!
Only use a dry cloth to clean the exterior of the device. To avoid damaging
the electronics, do not use any cleaning fluid. Protect the device from dust
and moisture.
DISPOSAL
Dispose of the packaging materials properly, according to their types, such as
paper or cardboard. Contact your local waste-disposal service or environmental
authority for information on the proper disposal. Do not dispose of electronic
devices in the household garbage! As per Directive 2012/19/EC of the European
Parliament on waste electrical and electronic equipment andits adaptation into
German law used electronic devices must be collected separately and recycled
in an environmentally friendly manner. In accordance with the regulations
concerning batteries and rechargeable batteries, disposing of them in normal
household waste is explicitly forbidden. Please make sure to dispose of your
used batteries as required by law — at a local collection point or in the
retail market. Disposal in domestic waste violates the Battery Directive.
Batteries that contain toxins are marked with a sign and a chemical symbol.
„Cd“ = cadmium, „Hg“ = mercury, „Pb“ = lead.
- battery contains cadmium
- battery contains mercury
- battery contains lead
WARRANTY
The regular warranty period is 2 years and begins on the day of purchase. To
benefit from an extended voluntary guarantee period as stated on the gift box,
registration on our website is required. You can consult the full warranty
terms as well as information on extending the warranty period and details of
our services at
www.bresser.de/warranty_terms.
Every purchase helps support the global non-profit National Geographic Society
in its work to protect and illuminate our world through exploration, research,
and education.
TO LEARN MORE, VISIT NATGEO.COM/INFO
© National Geographic Partners LLC. All rights reserved. NATIONAL GEOGRAPHIC
and Yellow Border Design are trademarks of the National Geographic Society,
used under license.
Visit our website:
www.nationalgeographic.com
Bresser GmbH
Gutenbergstr. 2
46414 Rhede
Germany
www.bresser.de
info@bresser.de
Bresser UK Ltd.
Suite 3G, Eden House
Enterprise Way • Edenbridge,
Kent TN8 6HF, Great Britain
Manual_9060100_Mobile-Power-Station_de-en-fr-it-es_NATGEO_v092022a
Errors and technical changes are reserved.
References
- art.no
- Bresser | Startseite | Expand Your Horizon mit BRESSER
- index · powered by h5ai 0.26.1 (http://larsjung.de/h5ai/)
- Bresser | NATIONAL GEOGRAPHIC Mobile Power Station | Expand Your Horizon
- National Geographic
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>