auto Land PS-M2 Vehicle Power Stabilizer User Guide

auto Land PS-M2 Vehicle Power Stabilizer

How to Start PS-M2 Operation

1. Connect with Power Outlet
   • Plug the adapter into AC Power Outlet.
2. Connect to Vehicle Battery
   • .First clamp the red positive cable to the intended vehicle’s positive battery terminal (marked as “+”). Then, clamp the black negative cable to the intended vehicle’s negative battery terminal (marked as “”).
3. Powered On but not ½\ctivatea
   • The default mode will be MAINTAIN mode.
   • When not activated, the voltage output status is OFF.
4. Activate Power Output
   • Press power key on top of the PS-M2. After 3 beeps, the blue LED indicates output action (MAINTAIN mode). The screen shows 12.BV, 10A (may slightly differ depending on the vehicle status).
5. Select Output Mode+
   • to Select the vehicle output equipment. mode to be used according to
   • are as following various output modes VOLT3: VOLT1: 15V 13.BV VOLT2: MAINTAIN: 14.4V 12.BV For description more below. information, please see the
6. Device in Service
   • PS-M2 will continuously provide stable 14.4V. The current value will be activately adjusted with current consumption of the vehicle.

Device in Service

Press Power Button

Remove Clamps from The Vehicle

Disconnect from Powen Outlet

• Remove adapter from AC Power Outlet.

Specification

1. Adaptive current output: 0-70A
2. Maximum output current: 72A in 13.BV mode.
3. When maximum output current is exceeded (70-99A), the system will automatically switch to “pulse” charging mode.
4. In maintenance mode, the voltage output will be fixed at 12.BV, and the current will be dynamic current output to ensure the battery life.

Protection

1. Heat dissipation is managed by robust heat sink and convection design to ensure the efficiency of the PS-M2.
2. In the case of incorrect connection or in the event of a short. Unit is equipped with reverse polarity protection and short circuit protection prevent damage to electrical damage.

Output Mode Description

• VOL T1: 15V Snow mode, provides large voltage output
• VOLT2: 14.4V Suitable for AGMNRLA/GEL battery types
• VOL T3: 13.8V Suitable for Lead-Acid battery type
• MAINTAIN: 12. BV Battery maintenance mode

Attention. On Warning buzzer and lights are listed below, please follow the instructions to operate PS-M2.

1. Screen flashes + “Beep” alarming sound
   • Not activated mode, please follow the normal operation and use.
2.  Screen flashes + “Beep” short and repetitive sound
   • Clamps are connected with the wrong terminals.
3.  Screen flashes + “Beep” short and repetitive sound
   • After entering the pre-charging mode, it will automatically switch to the normal mode after about 30 sec to 1 min. The charging time will vary depending on the battery status on the car.
4.  Screen flashes + “Beep” short and repetitive sound
   • Current overload, system shuts down automatically. Please remove the PS-M2 from the vehicle and pull the adapter from AC power outlet. Start operation procedure from the beginning.

Instruction of clip for new Mercedes-Benz models.

Documents / Resources

| auto Land PS-M2 Vehicle Power Stabilizer [pdf] User Guide
PS-M2, Vehicle Power Stabilizer, PS-M2 Vehicle Power Stabilizer, Power Stabilizer, Stabilizer
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>