wieland Gesis RST Classic Wall Socket Instruction Manual
- June 3, 2024
- wieland
Table of Contents
wieland Gesis RST Classic Wall Socket Instruction Manual
Important information
Please read carefully
This supplement describes the mounting and assembly of the gesis RST* CLASSIC Wall socket. It is strictly intended for use arid installation by trained electricians only. Please observe all the warnings and notations.
- Related technical information is available at www.wieland-electric.com.
- Please find specific instructions at the end of this document
General information
- For standard grid installation, Wieland Electric recommends the 3-pole divice connector with our gesis RST* CLASSIC sprino-cage connector (Art. 96.031.1053.1)
- Plug connectors are sold separately and are not included as a part of the packaged set.
- Divice connectors in the gems RSTs CLASSIC series can be installed in combination with this outlet (2-, 3-, 4- or 5-pole)
- The gesis RSPI wall socket outlet is intended for installation in combination with 60 cm flush-mounting boxes
- Strip the wires libeally of the-insulatidn to ease installation
- Please follow the regional installation regulations Further Information can be found at https.//eshop.wieland-electric.com
Wall Socket Assembly
Attention:
Open side of the seal face down
This wall socket set does NOT included the electric connector plug and hexagon nut.
Assembly instructions for manual release
Please note that if the manual release ring is mounted in the wrong direction, the cover will not snap into place and be completely assembled.
- The plug nose on the ring must point in direction of the cover (see no 1)
- The manual release ring-must be pushed under the two retaining pegs on the frame (see no. 2)
Correct
Incorrect
Connecting
Releasing
Cover Removal
Further information about Wieland Electric and our products can be found On our webpage.
2015 All rights reserved. This description, including all the diagrams, is protected by copyright. Third-party products are named without noting patent rights. The existence of these rights must therefore not be ruled out Changes of any type that are made in the hardware or software of the products described result in an exclusion of liability on the part of the manufacturer.
Hotline:
Tel: +49 (951) 9324-996
Fax: +49 (951) 9326.996
E-Mail: [email protected]
Internet: www.gesis.com
Wieland Electric GmbH
Brennerstral3e 10-14 96052 Bamberg
Tel: +49 (951) 9324-0
Fax: +49 (951) 9324-198
Internet: www.wieland-electric.com
E-Mail: [email protected]