lifeme mblu Blus Earbuds Owner’s Manual
- June 3, 2024
- lifeme
Table of Contents
lifeme mblu Blus Earbuds
Deer User,
Thank you for purchasing this product Please read this Product description tar
a better experience and fDIIDWthe instructions provided to perform actions.
Package list
- Ea orphaned x 2
- Charging case x 1
- Startups (LIS) x2
- OWner’s manual xl
Visitwww.mblu.com for information on other accessories.
overview
Brief Introduction
To connect to mobile devices, allow steps 1-2.
Charge
the blue Blust charge in the case and connect mblu Blust case with a USB-C cable/wireless charger to charge. Please charge at least 10 minutes for the first time use.
Turn on BT Turn on Bluetooth on your phone or another device
Connect to the device.
With mblu Blues in Case and lid open, press the button in the case until the
light blinks. Then go to Bluetooth settings and choose blue Blues.
Changing ear tips
Pull firmly to remove the tip. To attach tip, align it, then push until it
clicks For more tip sizes, see the inside box.
- Double-press to answer or hang up a call. 1=Th. (R)
- Triple-press to the Next song.(R) =TEH.
- Triple-press to the Previous song.(L)
- Press and hold to turn on/off
- Noise Cancellation mode.(R)
- Press and hold to turn on/off
- Transparency mode. (L)
- Long presS Land R side button at
- the same time to switch between
- “Game mode” and “Music mode”
Specifications
- BT 5.2 Bluetooth version: BT 5.2
- Impedance: 280 Maximum power: 8mW
- Sensitivity: 117dB
- Speaker diameter: 12mm
- Headphone battery capacity: 40mAh
- Charging box battery capacity: 520mAh
- Playtime: 6.5h Noise reduction: 6.5hours (headphones),
- E:280 H: 8mW 117dB
- R 0/: 12mm 40mAh 520mAh a:6.5h
- 6.5hours(EL), 30hours(E) 30hours (overall):5.5hours(ELL). 25hours(8)
- Noise reduction: 5.5hours (headphones),
- -42dB 25hours (overall)
- Microphone sensitivity: -42dB
- Bluetooth effective distance: 10M
- Frequency response range: 20Hz-20kHz
- Executive standard: GB 8898-2011
-
This product contains a built-in lithium battery. Do not expose the product to strong sunlight or fire or it might explode. Dispose of the battery according to local regulations. Do not dispose of it as domestic waste.
-
Do not remove or replace the product battery unless doing so is specified in the User Manual or in the Quick Start Guide, or you might damage the product.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS. -
Do not disassemble or refit the earphone for any reason as you may damage it or void the warranty.
-
Avoid contact with liquid to avoid serious damage to the earphone. The manufacturer does not cover water damage.
-
Avoid temperatures above 75 degrees and below minus 40 degrees.
-
Keep the indicator light away from children’s and animals’ eyes.
-
Do not use this product during thunderstorms to avoid electric shocks.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit
- different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet the general RF exposure requirements.
The device can be used in portable exposure conditions, and compliance with
exposure requirements.