thinkplus Q53 Wireless RGB BT Speaker User Manual
- June 3, 2024
- thinkplus
Table of Contents
Q53
Wireless RGB BT Speaker
User Manual
Wireless RGB BT Speaker
User Manual
Q53 Wireless RGB BT Speaker
Thank you for your choose this product, Your recognition has always been our driving force.
Instruction:
Before using this product pls carefully read the instruction first, to avoid any confused.
- Firstly please press the swich on/off button of this product. Then open your smart devices to connect the bluetooth name”Q53″, successfully connected you will hearing the “Ding dong” voice prompt for paring.
- After connected the bluetooth, you can play any music on your smart devices anytime anywhere then.
How to using:
Follows picture for the product buttons instruction.
- Switch On/Off button. Long press of 3 second for Switch on/off. Short press for Pause/Play function.
- Volume down/Previous song button. Long press will be change to previous song. Short press will be volume down.
- Volume up/Next song button. Long press will be change to next song. Short press will be volume up.
- Mode switch/RGB lights switch. Long press for mode switch(TF card mode, there will be a TF card insert the unit), Short press for change RGB lights mode. Dual press for connect/disconnect TWS function
- Type-c Charging port, the user connect the charging cable for get charging if the unit battery is low.
- TF card slot, insert TF card for play music(Remark: There is required music inside of the TF card)
FCC Caution:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) The device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions (1)this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. This equipment
complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
Thank you for your reading, hope you have a nice
experience!
Documents / Resources
|
thinkplus Q53 Wireless RGB BT
Speaker
[pdf] User Manual
Q53, 2A5AQ-Q53, 2A5AQQ53, Q53 Wireless RGB BT Speaker, Wireless RGB BT
Speaker, RGB BT Speaker, BT Speaker, Speaker
---|---