Ltc AUDIO MEGA50USB Rechargeable 50W Megaphone with Record Function User Manual
- June 3, 2024
- Ltc AUDIO
Table of Contents
Ltc AUDIO MEGA50USB Rechargeable 50W Megaphone with Record Function User
Manual
SPECIFICATIONS
- All ABS Body, sturdy yet light weight
- Built –in Siren & detachable Microphone
- Clear sound, long range & efficient design
- 16 Seconds Voice Recording Function
- Built-in rechargeable Li-ion battery
BEFORE YOU START
The megaphone can be powered via the built-in Li-ion battery or 8x ‘D’ cells.
Before the first use, open the battery compartment of the megaphone. Plug the
built-in Li-ion battery pack into the supplied mains adaptor. Let the battery
charge for about 6-8 hours. Once the battery pack is fully charged, open the
battery compartment, insert the battery pack and connect it to the 2 pin
socket.
You can also insert 8x D cells with the correct polarity. Close the battery
compartment.
OPERATION
MICROPHONE: Push the ON/OFF button on the side of the microphone to ON
position.
Set the USD/SD MIC switch on the left side to MIC position. Place your lips as
close as possible to the microphone and speak with a normal voice. Adjust the
volume to the desired level via the wheel on the right side of the microphone.
Don’t set the volume too loud in order to avoid howling and feedback.
If you don’t want to have the microphone switched on permanently, you can set
the ON/OFF button to OFF. Press the trigger button on the top front part of
the handle when you want to talk into the microphone. Keep the button pressed
while you are speaking.
SIREN: Press the SIREN button to activate the built-in siren. Press again to switch off the siren.
REC: Adjust the volume control to the min. before recording. Press the REC button and the indicator light will be on. Now your megaphone is ready for recording. The longest record time is about 16 seconds. Press the REC button after finishing recording.
PLAY: Press the PLAY button to listen to your recorded message.
USB, SD & AUX OPERATION
Set the USB/SD MIC switch on the left side of the megaphone to USB/SD
position.
Insert a USB stick, an SD card or connect the headphone output of an audio
source to the AUX connector (3.5mm jack) on the side of the megaphone. The
unit will automatically switch to the latest input source. If you want to
change the input source during operation, press the M button to cycle through
the USB, SD and AUX input sources. Push the switch to MIC position, if you
want to use the microphone.
To select the following track, press shortly the button. To select the last track, press shortly the button. If you keep one of these buttons pressed, the volume of the USB, SD or AUX source will increase ( ) or decrease ( ).
SPECIFICATIONS
Power Output: 25W Rated / 50W Max
Voice Range: 600m
Rechargeable battery: Li-ion
Power supply: 220-240Vac 50/60Hz
Charging time: 6-8 hours
Batteries: 8 x “D” Cells (not included)
Microphone: Unidirectional
Dimensions: Horn diam. 240 x 345mm
Weight: 1.65 kg w/o. Li-ion battery pack
Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local authorities or your dealer about the way to proceed.
Documents / Resources
| Ltc
AUDIO MEGA50USB Rechargeable 50W Megaphone with Record
Function
[pdf] User Manual
MEGA50USB Rechargeable 50W Megaphone with Record Function, MEGA50USB,
Rechargeable 50W Megaphone with Record Function
---|---