Kruger Matz KM0506C passive speakers Owner’s Manual

June 3, 2024
Kr ger Matz

Kruger Matz KM0506C passive speakers Owner’s Manual

Kruger Matz KM0506C passive speakers.jpg

Passive speakers
KM0502C
KM0504C
KM0506C

SAFETY INSTRUCTIONS

Read the instruction manual carefully before first use and keep it for future reference.

  1. Make sure to place this product on flat, dry and stable surface.
  2. place the device in a properly ventilated place.
  3. protect this product from moisture, humidity, water and any other liquid. Avoid using/storing it in extreme temperatures. Do not expose it to direct sunlight and sources of heat.
  4. keep the device beyond children’s reach.
  5. product suitable for indoor use only.
  6. Never use this device if the speaker cord is damaged.
  7. Speaker cord should be routed so that it is not likely to be pinched by items placed upon or against them.
  8. Do not attempt to repair or dismantle this device yourself. In case of damage, contact with an authorized service point for check-up/repair.
  9. Clean this device with soft, slightly damp cloth. Do not use any abrasives or chemical agents to clean this product.
  10. Never exceed the input power beyond the maximum input power of the speaker system.

SPEAKER INSTALLATION

Except the speaker units’ quality, the acoustic quality of the speaker system also depends on factors like the size and mode of rooms, speaker installation means and so on. Thus, please pay attention to the following points during installation:

  • When the speaker is placed directly on the floor, the subwoofer effect will be too obvious. Then one cement board or other hard support plate should be needed to be placed on the floor.

  • Attention: when the speaker and the sound source or the amplifier are placed on
    the same support object, the speaker may blare screams.

  • If there are walls or glass door behind or in front of the speaker system in the short distance, please note that heavy curtains should be needed on the wall orthe glass door in order to avoid unnecessary resonance and reverberation effect.

  • This model speaker system is with antimagnetic design. For most CRT television receivers, it can stand near the speaker without bad TV image result. But for some television, maybe the speaker is too close to it and results in image color damage. When this situation happens, please move the speaker a little away from the television.

CONNECTION

Please make sure that the amplifier is powered-off before connecting the speaker system.

Banana plugs
Use banana plug cables to connect the system.

FIG 1 Banana plugs.JPG

Speaker cables
Use the speaker cable to connect the speakers with amplifier (as shown on the illustration). please connect the left channel of the speaker to “L” terminal of the amplifier, and the right channel of the speaker should be connected to “R” terminal of the amplifier. Attention to the mark of positive pole and negative pole (with corresponding “+” and “-”). The inversion of positive pole and negative pole results

FIG 2 Speaker cables.JPG

SPECIFICATION

FIG 3 SPECIFICATION.JPG

Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with separate collection systems) This marking shown on the product or its literature, indicates that it should not be disposed with other household wastes at the end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources. Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase contract. This product should not be mixed with other commercial wastes for disposal.
Made in China for LECHPOL ELECTRONICS Sp. z o.o. Sp.k., ul. Garwolińska 1, 08-400 Miętne.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals