JBL 109PBENCRE Partybox Encore Essential Wireless Speaker User Guide
- June 4, 2024
- JBL
Table of Contents
109PBENCRE Partybox Encore Essential Wireless Speaker
User Guide
![JBL 109PBENCRE Partybox Encore Essential Wireless Speaker
- fig 3](https://manuals.plus/wp-content/uploads/2022/08/JBL-109PBENCRE- Partybox-Encore-Essential-Wireless-Speaker-fig-3.jpg)![JBL 109PBENCRE Partybox Encore Essential Wireless Speaker
- fig 5](https://manuals.plus/wp-content/uploads/2022/08/JBL-109PBENCRE- Partybox-Encore-Essential-Wireless-Speaker-fig-5.jpg)![JBL 109PBENCRE Partybox Encore Essential Wireless Speaker
- fig 7](https://manuals.plus/wp-content/uploads/2022/08/JBL-109PBENCRE- Partybox-Encore-Essential-Wireless-Speaker-fig-7.jpg)![JBL 109PBENCRE Partybox Encore Essential Wireless Speaker
- fig 9](https://manuals.plus/wp-content/uploads/2022/08/JBL-109PBENCRE- Partybox-Encore-Essential-Wireless-Speaker-fig-9.jpg)![JBL 109PBENCRE Partybox Encore Essential Wireless Speaker
- fig 11](https://manuals.plus/wp-content/uploads/2022/08/JBL-109PBENCRE- Partybox-Encore-Essential-Wireless-Speaker-fig-11.jpg)
Note: The product is in compliance with the European Union energy legislation.
-
Bluetooth/TWS connection mode
The product is intended to be used for streaming music via Bluetooth connection. A consumer can stream Bluetooth audio to the speaker. When the product is connected through Bluetooth, the Bluetooth connection must remain active at all times to ensure proper operation.
The product will enter sleep mode (networked standby) after 20 minutes without operation. The power consumption in sleep mode is less than 2.0 Watts, after which it can be re-activated via Bluetooth connection. -
Another mode
The maximum operating temperature is 45 °C No naked flame sources, such as lighted candles, should be placed on the apparatus.
This equipment is a Class II or double-insulated electrical appliance
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth
SIG, Inc., and any use of such marks by HARMAN International Industries,
Incorporated is under license. Other trademarks and trade names are those of
their respective owners.
Safety Instruction and Warranty Card
PRODUCT REGISTRATION
register.jbl.com
SIGN UP & STAY TUNED
Register your product
product registration may not be available for all countries
SCAN ME
https://register.jbl.com/?utm_source=WQR
Download the full warranty Card Safety Information and other helpful
information from our
website:
www.jbl.com/warrantyandsafetybooks
https://www.jbl.com/warrantyandsafetybooks
IMPORTANT SAFETY INSTRUCTIONS
For all products:
- Read these instructions.
- Keep these instructions.
- Heed all warnings.
- Follow all Instructions.
- (Inn only with a dry cloth.
- Do not blod. any ventilation openings. Install this apparatus in an ordinance with the manufacturer’s instructions.
- Do not Instil this apparatus near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat
- Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades one wider than the other. A grounding-type plug has two blades and a third grounding prong The wide blade or the third prong is provided for your safety. If the provided plug does not fit Into your outlet wise an electrician for replacing the obsolete outlet
- Protect the power cord from being walked on or pinched. particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
- Use only attachments/accessories specified by the manufacturer.
- Use only with the art, sunset tripod, bracket, or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over
- Unplug this apparatus during lightning storms or when unused for long periods of time.
- Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as when the power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, or the apparatus has been exposed to rain or moisture, does not operate normally or has been drooped.
- To disconnect this apparatus from the AC mains completely, disconnect the power-supply cord plug horn from the AC receptacle.
- The main plug of the power-supply cord shall remain readily operable.
- This apparatus is intended to be used only with the power supply and; charging cable provided by the manufacturer.
The following instructions may not apply to waterproof devices. Refer to your device user manual or gum start guide for more waterproof instructions if any.
- Do not use this apparatus near water.
- Do not expose this apparatus to dripping or splashing, and ensure that no objects filled with liquids, such as vases, are placed on the apparatus.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE.
CAUTION
RISK OF ELECTRIC SHOCK. DO NOT OPEN.
THIS SYMBOL ON THE PRODUCT MEANS THERE IS AN UNINSULATED, DANGEROUS VOLTAGE
WITHIN THE PRODUCT ENCLOSURE THAT MAY PRESENT A RISK OF ELECTRICAL SHOCK.
THIS SYMBOL ON THE PRODUCT MEANS THERE ARE IMPORTANT OPERATING AND MAINTENANCE
INSTRUCTIONS IN THIS GUIDE.
CAUTION FCC AND IC STATEMENT FOR USERS (USA AND CANADA ONLY)
This device complies with part 1S of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference. and
- this device must accept any interference received, including interference that may cause undesired operation. CAN ICES-3(B)/NMB-3(B)
FCC DOC SUPPLIER’S DECLARATION OF CONFORMITY
HARMAN International hereby declares that this equipment is in compliance with
the FCC Part 15 Subpart B. The declaration of conformity may be consulted in
the support section of our Web site, accessible from
www.jbl.com
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules, These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by HARMAN could
void the user’s authority to operate the equipment.
For Products That Transmit RF Energy:
-
FCC AND IC INFORMATION FOR USERS
This device complies with Part 15 of the FCC rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause harmful interference; and (2) this device must accept any interference received, including nterference that may cause undesired operation. -
FCUIC Radiation Exposure Statement
This equipment complies with FCC and ISED radiation exposure limas set forth for an uncontrolled environment In case this equipment has to be subject to KC/IC SAR (Specific Absorption Rate) exposure test, this equipment is designed to meet the requirements for exposure to radio waves established by the FCC and ISEC. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the body or on the head, with no separation. To meet RF exposure guidelines and reduce exposure to RF energy during the operation, this equipment should be positioned at least this distance away from the body or the head.
For radio equipment operating in 5150-5850MHz FCC and IC Caution:
High-power radars are allocated as primary users of the i.25 to 5.35 GHz and
5.65 to 5.85 GHz bands. These radar stations can cause interference with
and/or damage to LE LAN (licence-Exempt Local Area Network) devices. No
configuration controls are provided for this wireless equipment allowing any
change in the frequency of operations outside the FCC point of authorization
for US operation according to Part 15.407 of the FCC rules.
For devices with headphone jacks,
WARNINGS/CAUTIONS
Do NOT use the headphones at a high volume for an extended period
- To cold hearing damage. use your headphone, -0 comfortable, moderate volume level
- Turn the volume down on your device before the headphones on your ears. then turn the volume up gradually until you reach a comfort)* listening level.
For Products That Include Batteries
Instructions for then on Removal. Recycling and Disposal of Used Batteries
To remove the batteries from your equipment or remote contra reverse the
procedure described in the owner’s manual for muting batteries for products
with a built-in battery that lasts for the Wehrle of the product. removal may
not be possible for the user, In this case, reading or recovery centers handle
the dnmanthnq of the product and the removal of the battery H. for any reason,
it becomes necessary to replace such a battery, this procedure must be
performed by authorized service centers In the European Union and other
locations, it is illegal to dispose of any battery with household trash. All
batteries must be disposed of in an environmentally sound manner. Contact your
local waste-management officials Herniation regarding the environmentally
sound collection. recycling and disposal of used batteries.
WARNING: Danger of explosion if the battery is incorrectly replaced. To reduce the risk of fire, explosion, or leakage of flammable liquid/gas, don’t disassemble, Gush, puncture, or short external contact. expose to temperatures above 604C 11401), sunshine or like. expose to extremely low au pressure or dispose of in fire or water. Replace only with specified batteries. The symbol inducing ‘separate collection’ for ad batteries and accumulators shall be the crossed-out wheeled bin shown below
WARNING – For Products Contain Coin/Button Cell t series .4.01 INGEST
BATTERY, CHEMICAL BURN WARD This product contains a button cell battery. If
the combined ce0 battery is %wakened, rt can severe internal burns In just 2
Noun and can lead to death. Keep new • Used batteries away from children. If
the battery compartment does not secure, stop using the product and keep it
away from children. If your batteries might have been swallowed or plated
inside any part of the seek immediate medical attention.
For All Products with Wireless Operation :
HARMAN International hereby declares that this equipment is in compliance with
the essential requirements and other relevant provisions of Directive
2014/53/EU The declaration of conformity may be consulted In the support
section of our Web site, accessible from www.jbi.com
HARMAN Inte S.oral Industries. Incorporated rights reserved is a trademark of
HARMAN International Industries, Incorporated, registered In the United States
and/or other countries’ Features. specifications and appearance ate subject to
change without notice
www.jbl.com
HARMAN
International Industries, Incorporated 8500 Balboa Boulevard, Northridge,
CA 91329 USA 516.2S5.4545 (the USA only)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>