coolme Stage GoFree Portable Bluetooth Speaker User Guide

Stage GoFree Portable Bluetooth Speaker

Product Specifications

• Dimensions: 79*120mm
• Weight: 100g
• Compliance: Part 15 of FCC Rules

Product Usage Instructions

Charging Your Mobile Device

1. Ensure the device is connected to a power source.

2. Connect your mobile device to the charger using a compatible
   cable.

3. Wait for the device to charge fully. The charging indicator
   will typically show when the device is fully charged.

4. Once charged, disconnect your mobile device from the
   charger.

Interference Troubleshooting

If you experience interference with radio or television
reception while using this equipment, follow these steps:

• Reorient or relocate the receiving antenna to improve signal
  reception.

• Increase the distance between the equipment and the receiver to
  minimize interference.

• Plug the equipment into a different outlet on a separate
  circuit from the receiver.

• If issues persist, seek assistance from the dealer or a
  qualified radio/TV technician.

FCC Radiation Exposure Statement

The device complies with general RF exposure requirements and
can be used in portable exposure conditions without
restrictions.

Frequently Asked Questions (FAQ)

Q: How do I know if my device is causing interference?

A: Interference can be detected by disruptions in radio or
television reception. If you notice such disturbances, try the
interference troubleshooting steps provided in the manual.

Q: Can I use the device in areas with high RF exposure?

A: Yes, the device is evaluated to meet RF exposure requirements
and can be used in portable exposure conditions without
limitations.

79*120mm 100

CHARGE YOUR MOBILE DEVICE

FCC Warning Statement: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

IC Warning This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. This device complies with Canadian ICES-003 and RSS-247. Radiation Exposure: This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment. IC Radiation Exposure Statement The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Avertissement IC Cet appareil est conforme aux normes RSS sans licence d’Industrie Canada. L’opération est soumise aux deux conditions suivantes: (1) cet appareil ne doit pas causer d’interférences, et (2) cet appareil doit accepter toute interférence, y compris celle susceptible de provoquer un fonctionnement indésirable de l’appareil. dispositif. Selon la réglementation d ‘Industrie Canada, cet émetteur radio ne peut fonctionner qu ‘en utilisant une antenne type et gain maximum (ou inférieur) approuvés pour Industrie Canada par l’émetteur. Réduire brouillage radioélectrique potentiel avec d’autres utilisateurs, le type d’antenne et son gain doivent être choisis que la puissance isotrope rayonnée équivalente (e.i.r.p.) n’est pas supérieure à celle nécessaire pour communication réussie. Cet appareil est conforme aux normes canadiennes ICES-003 et RSS-247. Exposition aux radiations: Cet équipement est conforme à la réglementation canadienne sur les radiations. limites d’exposition établies pour un environnement non contrôlé. Déclaration d’exposition aux radiations IC L’appareil a été évalué pour répondre aux exigences générales d’exposition aux RF. L’appareil peut être utilisé sans restriction dans des conditions d’exposition portables.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>