TURTLE BEACH MAAB0008 Gaming Mouse Review User Guide

: September 28, 2024
: TURTLE BEACH

Table of Contents

TURTLE BEACH MAAB0008 Gaming Mouse Review
PACKAGE CONTENTS
DEFAULT BUTTON ASSIGNMENT
INTRODUCTION
LED INDICATION
DRIVERLESS SETUP
TECHNICAL FACTS
Documents / Resources

TURTLE BEACH MAAB0008 Gaming Mouse Review

PACKAGE CONTENTS

DEFAULT BUTTON ASSIGNMENT

STANDARD

Left click
Right click
Middle click
Tilt Left
Tilt Right
Scroll Up
Scroll Down
DPI up
DPI down
Browser Forward
Browser Backward
Easy-Shift[+]™

EASY-SHIFT[+]™

Left click
Right click
Play/Pause
Previous Track
Next Track
Volume Up
Volume Down
Next Profile
Previous Profile
Page Up
Page Down
Easy-Shift[+]™

INTRODUCTION

Remove the blue protective plastic from the mouse feet.
Plug the USB connector into any free USB port on your PC or laptop.
Navigate to www.turtlebeach.com/swarm2 and download the latest driver software.
Complete the installation to get access to all software features and setup.

LED INDICATION

Once the mouse is plugged in, pressing the DPI button will change the DPI and show a corresponding color on the indicator for 2 seconds. The color is shown as below:

1st stage
Red (default DPI value: 400)
2nd stage
Green (default DPI value: 800)
3rd stage
Cyan (default DPI value: 1200)
4th stage
Blue (default DPI value: 1600)
5th stage
Pink (default DPI value: 3200)

The number of active DPI stages on your mouse can be changed in the driver software, along with the DPI value for each stage.

DRIVERLESS SETUP

To enter config mode: Hold down buttons 1, 2, 3 and 8 (default left click, right click, middle mouse, and DPI+) for 3 seconds to enable config mode. The LED will show a sequence of white, red, green, then blue.
To exit config mode: Press buttons 1, 2, 3 and 8 at the same time once. The LED will show a sequence of blue, green, red then white.
While holding button 1 (left mouse button), buttons 10 & 11 (browser forward & browser backward):
Change LED brightness (steps of 10%). The LED will immediately change.
While holding button 2 (right mouse button), mouse wheel up/down:
Change LED Color (16 preset colors). The LED will immediately change. (This will not affect Wave mode)
While holding button 2 (right mouse button), buttons 10 & 11 (browser forward & browser backward):
Change LED mode (choose from Static, Wave, Heartbeat, Breathing, and Blinking). The LED will immediately change.
Buttons 10 & 11 (browser forward & browser backward):
Change polling rate. The LED will blink twice in the color of the selected polling rate:
- 125Hz Blue
- 250Hz Green
- 500Hz Yellow
- 1000Hz White (default)

Button 3 (middle mouse button):

Swap between 1mm and 2mm lift-off distance. The LED will blink twice in the color of the selected lift-off distance:

1mm Red (default)
2mm Purple

While holding button 1 (left mouse button), mouse wheel up/down:
Change debounce value. The LED will blink twice in the color of the selected debounce value:

2ms Orange
5ms Purple (default)
10ms Cyan

TECHNICAL FACTS

TECH SPECS

Sensor: Owl-Eye 26K DPI
Min/Max DPI: 50 /26000
Adjustable Lift-Off Distance
Acceleration: 50g
IPS Tracking Speed: 650
USB Report Rate: 1,000Hz
NVIDIA Reflex: Yes
On-Board Memory: Yes (5 Profiles)
Cable: 1.8m / 5.9ft USB-A PhantomFlex™
Software: Swarm™ II
Approx. Weight: 90g

SYSTEM REQUIREMENTS

Windows® 10 and above (software support)
1× USB 2.0 port (or higher)
Internet connection (for driver installation)

Regulatory Compliance Statements for the Kone II

Certification Model: MAAB0008
FCC CAUTION:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation
Caution : Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

FEDERAL COMMUNICATIONS COMMISSION (FCC) COMPLIANCE NOTICES

CLASS B INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

ISED CANADA COMPLIANCE STATEMENT
This device complies with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions :

This device may not cause interference; and
This device must accept any interference, including interference that may cause undesired operation of the device.

European Union and European Fair Trade Association (EFTA) Regulatory Compliance
Declaration of Conformity:

Marking by this symbol:

Hereby, Voyetra Turtle Beach Inc. declares that Kone II is in compliance with Directive 2014/30/EU(EMC), 2014/35/EU(Safety), 2015/863 amending Annex II to 2011/65/EC(RoHS), 2012/19/EU (WEEE), 2006/1907/EU (REACH), 94/92/EU (PACKAGING), Electromagnetic Compatibility Regulations 2016(EMC), Electrical Equipment Regulations 2016(Safety), The Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012. The full text of the EU/UK declaration of conformity is available at the following internet address: http://www.turtlebeach.com/homologation

This symbol on the product or its packaging indicates that this product must not be disposed of with your other household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the recycling of waste electrical and electronic equipment. The separate collection and recycling of your waste equipment at the time of disposal will help conserve natural resources and ensure that it is recycled in a manner that protects human health and the environment. For more information about where you can drop off your waste for recycling, please contact your local authority, or where you purchased your product.

Turtle Beach Europe Ltd is obligated as a producer with a main activity of selling under The Producer Responsibility Obligations (Packaging Waste) Regulations 2007. To fulfill our obligation we are registered with Comply Direct and their Recycling Room. Here you will find advice and information on packaging waste management, recycling symbols and the waste hierarchy principles of reduce, reuse and recycle. https://www.complydirect.com/the- recycling-room/
For instructions in other languages, please visit http://www.turtlebeach.com/homologation

For warranty information and service, please visit w ww.turtlebeach.com/warranty

WARRANTY SERVICE FOR PURCHASES IN AUSTRALIA
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. For complete details please visit www.turtlebeach.com/warranty. To make a warranty claim in Australia during the Warranty Period, Purchaser should contact the VTB repair centre: Tecworks International Pty Ltd, 13 Distribution Place, Seven Hills NSW 2147, Tel: 1300 074 512

VOYETRA TURTLE BEACH, INC. | 44 SOUTH BROADWAY, 4TH FLOOR, WHITE PLAINS, NY 10601, USA
© 2024 Voyetra Turtle Beach, Inc. All rights reserved. Any product names mentioned in this manual may be trademarks or registered trademarks and are the property of their respective owners. Information contained herein is subject to change without notice. Voyetra Turtle Beach, Inc shall not be made liable for any errors that may appear in this manual. This publication or parts of it may not be reproduced without the express consent of the publisher. https://bsmi.turtlebeach.com/

Documents / Resources

| TURTLE BEACH MAAB0008 Gaming Mouse Review [pdf] User Guide
MAAB0008 Gaming Mouse Review, MAAB0008, Gaming Mouse Review, Mouse Review, Review
---|---