FORCE1 CNP1050 Cyclone Fast Action Stunt Car User Manual
- June 5, 2024
- FORCE1
Table of Contents
CNP1050 Cyclone Fast Action Stunt Car
User Manual
Thanks for buying the Force Cyclone Fast-Action Stunt Car! Read on for
detailed info on how to keep the Cyclone in action. Get ready – a storm is
coming!
FOR MORE INFORMATION
Visit us online at forcedrc.com for product
information, replacement parts, and tutorials.
BATTERY CHARGING
Your Cyclone comes with a 3.7v 500mAh battery installed and is ready to race! Please follow the instructions below to charge the battery when needed.
- Use a Phillips screwdriver (not included) to open the hatch on the black side of the Cyclone
- Remove the battery
- Plug it into the included USB charger until you hear a “click”
- Plug the USB charger into a USB port – the USB light will turn red
- Charge until the light turns off
- Plug back into the Cyclone, replace the hatch and get back in the race
NOTE Charging times vary, but typically take 1-2 hours for a full charge.
(TIP: You can increase battery life by fully depleting and fully recharging
your battery each time. You can also use a 5V 2A AC adapter (not included) for
faster charging.)
LI-PO BATTERY DISPOSAL & RECYCLING
Do not put lithium-polymer batteries in household trash. Please contact your
local waste management agency or U-Po battery recycling center for more info.
LI-PO BATTERY CARE
Avoid Overheating
Your batteries will sometimes be warm/hot to the touch after use. This is
normal, but beware that battery components will fail if not allowed to cool
down between uses. Also, do not leave batteries exposed to direct sunlight.
Store Properly
Store batteries at room temperature, between SC°/40°F and 27°C/80°F.
Use Carefully
- Leave time between charging and using the battery
- To extend the lifetime of the battery, always keep about 20% of the power remaining in the RC car battery (rather than completely draining it)
- If the battery is pushed beyond its limits, the battery could get hot and the performance will drop
- When using the battery for a long time, the battery will increase in temperature. If it is sealed, the air inside will inflate rapidly causing further heating
Charging
- DO NOT overcharge the battery; never charge batteries unattended, and stop charging as soon as your batteries indicate they are charged
- DO NOT attempt to charge batteries that appear damaged in any way (cracking, swelling, discoloration, etc.)
- If you feel a battery isn’t charging properly, try using another charger if possible. If you find your battery or charger is defective, please visit forced rc.com for a replacement, or email us at supporaforcelrc.com
- To inspect a battery, remove it from the device and examine the battery, battery pins, and contacts. If you notice damage, please visit forcelrc.com for a replacement, or email us at supportekforcelrc.com
- Check your battery and connections after every crash
- Please use genuine factory parts and replacements from forcelrc.com
WARNING:
DO NOT LEAVE BATTERY CHARGING UNSUPERVISED
CAUTION
- Keep fingers, hair, and loose clothing away from the Cyclone while it is on
- Adult supervision is recommended when the Cyclone is in use
- To avoid an accidental or unwanted operation, remove the battery when not in use
- Always turn the Cyclone off before removing the battery
BOX CONTENTS
REMOTE CONTROL BATTERY INSTALLATION
The Cyclone remote control requires 4 AA batteries (not included). Slide open
the cover on the back of the remote, install as directed and slide the cover
back into place.
CAUTION:
- Insert batteries in correct polarity (+) and (-)
- Don’t mix old and new batteries
- Don’t mix alkaline, standard (carbon-zinc), and rechargeable (nickel-cadmium) batteries
- Remove rechargeable batteries before charging
- Only charge batteries under adult supervision
- Remove spent batteries from the remote control
- Regularly inspect the charging cable, plug, and other parts; if you notice damage, please visit Forcerc.com for a replacement, or email us at support@forcelrc.com
2.4 GHz REMOTE CONTROL OVERVIEW
**CYCLONE OVERVIEW**
OPERATING INSTRUCTIONS
Your Cyclone car comes with a 3.7v 500mAh battery installed and is ready to
race. Once your remote control batteries are installed, switch it on FIRST,
then switch the Cyclone on LAST. Now, you’re ready to go!
CONTROLS
The Cyclone is super easy to control! Take note of the arrows on the
directional control pads. Use the left control pad to go forward and backward,
and use the right control pad to go left or right.
START CYCLONE MODE
Release the directional controls and press the red button on the top left of
the remote control to engage Cyclone Mode!
STOP CYCLONE MODE
Push either directional control pad to take control of the Cyclone once more.
NOTE If the Cyclone does not respond, it may mean its battery has lost
its charge during shipping. Never fear! See page 3 for instructions on how to
charge the Cyclone battery.
SUPPORT
Force is a family-owned company based in the Pacific Northwest, and we take
great pride in our toys. Please contact us at support
forcerc.com if you ever have any questions or comments
about your Force RC product.
FCC Regulatory Information
FCC ID: 2AM5MSW001598
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
Suppose this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on. In
that case, the user is encouraged to try to correct the interference by one or
more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver
-Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (1) this device must accept any interference received,
including interference that may cause undesired operation.
To ensure that play is both safe and fun, please review these operating
instructions:
Failure to follow all safety instructions may result in injury or property
damage none of which Force will be held liable for as proper warnings are
outlined in the manual.
- Upon use of this product, the end-user assumes all responsibility and Force cannot be held liable for any personal injury and/or property damage.
- This item contains fast-moving parts, motors, and/or another wiring.
- When using it, basic precautions should always be followed including but not limited to the following:
- Keep your eye on the product at all times
- Tie back hair or wear a hat to avoid entanglement or injury
- Keep hands, hair, and loose clothing away from moving parts when the power switch is turned ON.
- Please ensure the product is turned off when not in use.
WARNING
CHANGES OR MODIFICATIONS TO THIS UNIT NOT EXPRESSLY APPROVED BY THE SELLER
WILL VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>