VOLT VHS-6100-4-BBZ Thin Hooded Integrated Step Light Installation Guide

: September 25, 2024
: VOLT

Table of Contents

VHS-6100-4-BBZ Thin Hooded Integrated Step Light
IMPORTANT SAFETY INSTRUCTIONS
PACKAGE CONTENTS
PRODUCT DIMENSIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

INSTALLATION INSTRUCTIONS
VOLT® LOW VOLTAGE LANDSCAPE LIGHTING
VO LT® Thin LED Brass Step Light
ITEM: VHS-610X
1-813-978-3700 • Mon-Fri 8am-8pm
Sat-Sun 10am – 6pm (EST)

VHS-6100-4-BBZ Thin Hooded Integrated Step Light

INSTALLATION INSTRUCTIONS
VOLT® Thin LED Brass Step Light VHS-610X
IMPORTANT: PLEASE READ BEFORE INSTALLATION
This luminaire is intended for installation in accordance with local codes and the National Electric Code (NEC). Failure to adhere to these codes and instructions may result in serious injury, property damage and void the warranty.
These instructions do not intend to cover all variations in installation, operation maintenance or mounting situations.

Make sure that the power is turned OFF before installing or servicing this fixture.
Warning: this fixture is not intended to be installed within 10 feet [3 meters] of a pool, spa or fountain.
This fixture is intended to be used only with a power supply (transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.
Underground Low Energy Cable must not be buried over 6” (15.2 cm) in order to connect to the main low voltage cable.
Wiring connections must be made with UL Listed wire connectors that are suitable for the application.
Position the wire connector so that it is located within 6 inches (15.2 cm) from a building structure, a luminaire, or fitting.

IMPORTANT SAFETY INSTRUCTIONS

INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS LIGHTED LAMP IS HOT!
WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.

Turn off/unplug and allow to cool before reducing lamp.
Lamp gets HOT quickly!
Do not touch the hot lens, guard or cowl.
Keep lamp away from materials that may burn.
Do not touch lamp at any time.
Use a soft cloth.
Oil from skin may damage lamp.
Do not operate the fixture with a damaged or missing lens or shield.

PACKAGE CONTENTS

A. (1) Luminaire
B. (2) Anchors
C. (2) Screws

PRODUCT DIMENSIONS

1. Install Luminaire
NOTE:
Must be mounted with the wire exit on the left. Note: Anchors are required for concrete or brick walls.
Hold the luminaire on the wall and mark two points for the anchors using the mounting holes as guides. Then drill the proper holes using the marks. Insert the anchors into the drilled holes.
Attach the luminaire onto the desired mounting surface and secure with the screws. Hand tighten until snug with a screwdriver. Last, caulk around fixture to ensure it is sealed from water.
2. Wire Connections
Strip both leads from the luminaire pigtail. Using two wire connectors (sold separately), connect the leads from the luminaire to the main supply cable leads.
1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am – 6pm (EST)
Specifications and product details subject to change without notice.
© Copyright 2023, VOLT® Lighting, Lutz FL USA 33549 • All rights reserved.
customersupport@voltlighting.com
www.voltlighting.com