FENLO FEN106CCT Display Shelves User Manual
- September 24, 2024
- FENLO
Table of Contents
FENLO FEN106CCT Display Shelves
Accessory
A Bolts| B Bottom Boa| C Poles| D Two-Sided Bolts| E
LED Module and Glass She| F Power Cord| G Power Adapter| H
Remote| I Cushions
---|---|---|---|---|---|---|---|---
8PCS
|
1PC
|
16PCS
|
12PCS
|
4PCS
|
1PC
|
1PC
|
1PC
|
4PCS
Installation
-
Screw the bolts (A) into the four poles(C) through the bottom board (B). Then place the four cushions (I) on top of the screw holes for added stability.
-
Attach one level of the LED module with glass D C shelving (E) into the poles from Step 1 using four two-sided bolts (D), and then add another A level of poles (C) onto the I other side of the bolts.
-
Add another layer of the LED module and glass shelve (E) and another layer of poles (C) by using the two-sided bolts (D).
-
Repeat step 3.
-
When adding the �nail LED module and glass shelf (E), screw in four regular bolts this time(A).
-
Using the power cord section (F) connect one by one all four plugs into all four led glass modules. Ensure that all are secured in place.
-
Connect the power cord and foot switch (F) with the power adapter (G). Insert the male connector into the empty space within the female side and turn clockwise to secure.
-
Our display shelves are now enhanced with Correlated Color Temperature (CCT) technology. You can now report lessly transition between warm and cool toned lighting (2700Kto6000K).With our user-friendly app and remote control, you now have the power to tailor the lighting tone of your product.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between
the equipment and receiver. Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. Consult the dealer or
an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF Exposure Information
Floor Lamp
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
Remoter Control
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment can be used as portable exposure without any restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>