BOSCH MFQ36460 Hand Mixer Instruction Manual
- June 3, 2024
- Bosch
Table of Contents
BOSCH MFQ36460 Hand Mixer
Intended use
This accessory is designed for the hand mixer MFQ364.. . Follow the operating
instructions for the hand mixer.
Do not use the stand for other hand mixers.
When using the stand, only use the tools supplied with the appliance.
This accessory is only suitable for kneading dough, whisking egg whites and
beating cream and light dough.
The accessory must not be used for processing other objects or substances.
Safety instructions
Risk of injury!
- Before attaching or removing the hand mixer, wait until the drive has come to a standstill and pull out the mains plug.
- Whenever the swivel arm is lowered, do not reach into the housing to avoid your fingers or hands getting caught. Do not adjust the swivel arm while the appliance is switched on.
Important!
It is essential to clean the accessory thoroughly after each use or after it
has not been used for an extended period. X “Care and daily cleaning”
Overview
X Fig. A
-
Appliance stand with swivel arm
- Drive gear wheel
- Locking mechanism for hand mixer
- Lever for locking mechanism
- Opening for hand mixer
- Release button for swivel arm
- Base for bowl
- Bowl drive
-
Bowl
-
Hand mixer MFQ364..
- Opening for locking mechanism
- Base / holder
Tools
-
Turbo stirring whisks (x2)
- Worm drive gear
-
Kneading hooks (x2)
- Worm drive gear
Operation
For kneading dough, whisking egg whites and beating cream and light dough.
Always observe the maximum quantities and processing times in the table.
X Fig. C
X Fig. B
-
Place the appliance stand on a smooth and level work surface. Press the release button and raise the swivel arm to the stop.
-
Place the bowl on the base. The edge of the bowl must completely cover the bowl drive and the bowl should rotate easily.
-
On the hand mixer:
Move slider to position w. The apertures for inserting the tools are open, and the rear aperture is closed. -
Insert required tool pair (stirring whisks or kneading hooks) into the hand mixer and press into position.
Important! Only use tools that came with the stand.- Note the shape of the plastic parts on the tools to avoid mixing them up.
- Insert tools one after the other to stop them from getting caught!
-
Fit the back of the hand mixer onto the support so that the docking area engages in the opening on the support.
-
Hold the support and press the hand mixer down until it locks into place. Ensure that the worm gear and gear wheel mesh together correctly!
-
Press the release button and push the swivel arm down until it locks into place.
-
Insert the mains plug. Move the switch to the desired setting.
-
Process the ingredients until you achieve the required result.
-
Move the switch to 0. Wait until the drive comes to a standstill. Disconnect the mains plug.
-
Press the release button and raise the swivel arm to the stop.
-
Pull the lever on the swivel arm backwards and remove the hand mixer.
-
Press the ejector button on the hand mixer and remove the tools.
- Remove the bowl.
Note: To make dough, first put the flour and then the other ingredients
in the bowl and mix briefly at the lowest setting. When the flour is no longer
dusty, change to a higher setting. If the bowl and tools are rotated
in opposite directions, a loose dough is formed after a short while.
Care and daily cleaning
The accessories must be thoroughly cleaned after each use. X Table D
Caution!
Follow the instructions in the manual for the hand mixer without fail.
- Wipe down the stand with a soft, damp cloth and dry off.
- Clean the bowl and tools with dishwashing detergent and a soft brush or put them in the dishwasher.
- Allow all parts to dry.
Subject to change.
References
- Home Appliances Global Website | Bosch
- Home Appliances Global Website | Bosch
- Bosch Service | Service worldwide
- Welcome to MyBosch