Urbanears Luma Headphones User Guide

Urbanears Luma
User guide

|
---|---

First time setup

1. Open the case and take the earbuds out.

2. Remove the protective plastic strips and put the earbuds
   back in the case.

3. Take out the earbuds and put them in your ears.

4. Select Urbanears Luma from your device’s Bluetooth®menu.
   Touch control
   Double-tap any earbud
   Play/pause, answer a call, or hang up
   Wireless charging case
   Put your earbuds back into the case to recharge, a fully charged case can recharge both earbuds up to 5 times. The LED indicator on the case shows its battery level, from green (full), through orange to red (low). Place the case on a wireless charger or connect it to a USB power source via the included USB-C cable. When your earbuds are in the case, they turn off. Taking them out will turn them on and try to reconnect.
   Overview

Earbuds
1. Touch control surface
2. Earbud LED indicator
3. Microphone for phone calls
4. Auto-pause sensor| Wireless charging case
5. Case battery LEDindicator
6. USB-C port for charging
---|---

Pairing with another device
You can easily change from one connected device to another.

1. Open the Bluetooth menu on the device that your earbuds are currently connected to and disconnect Urbanears Luma.
2. The earbuds are now in pairing mode and ready to connect.
3. Open the Bluetooth menu on the device you want to connect to and select Urbanears Luma.

Resetting your earbuds
If you have problems pairing your earbuds or they become erratic or unresponsive, perform a hardware reset.

1. Put your earbuds in the charging case.
2.  Take out your earbuds of the case.
   If the problem persists, perform a factory reset.

Note: This will delete all information about previously paired devices.

1.  Put your earbuds in the charging case.
2. While in this case, press and hold the touch control surface on both earbuds for 10 seconds.
3. Take out the earbuds and put them in your ears.
4. Double-tap both earbuds and they will be reset to factory settings.

Pairing after factory reset

1. Open the Bluetooth menu on the device that your earbuds were previously connected to and remove Urbanears Luma.
2. Take out the earbuds, wait for 5 seconds, and put them in your ears.
3. Select Urbanears Luma from your device’s Bluetooth menu.

© Zound Industries International AB. All rights reserved. The wordmark, logotype, headphone, and packaging are intellectual properties of Zound Industries International AB. The Bluetooth® wordmark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by Zound Industries is under license.
Zound Industries International AB, Centralplan 15, 111 20 Stockholm, Sweden. Designed in Stockholm. Produced in China.
R.1.5

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>