CMA DISHMACHINES CMA-180VL-FL High Temp Ventess Front Loader Dishwasher Instruction Manual
- September 14, 2024
- CMA Dishmachines
Table of Contents
CMA DISHMACHINES CMA-180VL-FL High Temp Ventess Front Loader Dishwasher
CMA-180VL-FL
Quick Setup Instructions
-
Connect a 2″ drain pipe (not supplied) from scrap accumulator to floor (recommended) or wall drain.
-
Connect dishmachine to hot water source 120°F – 140°F.
-
Connect cold water inlet (min 41°F and max 65°F).(Review other side for details).
-
3 Phase: Connect power supply wires, L1, L2 and L3 to the appropriate terminals marked L1, L2 and L3 on the power block. Important: If one of the three wires has higher voltage it must be inserted as L-2.
-
Remove the plastic plug to install the detergent fitting (provided by your dispenser supplier; CMA does not supply).
-
Remove the plug from the mixing chamber and install the rinse injection fitting (rinse injection fitting provided by your dispenser supplier; CMA does not supply).
-
Press “POWER ON/OFF” rocker switch to turn on dish machine.
-
Press “RINSE/START ROCKER SWITCH” to fill the booster tank.
-
Adjust pressure regulator located next to cold water inlet, to 20 psi (maximum).
-
Press “RINSE/START ROCKER SWITCH” to start.
-
Press ” AUTOFILL ” immediately after power is turned on. Timer will automatically fill until the water overflows into the scrap trap.
-
Adjust the temperature by removing the panel in front of the respective heater and turning the adjustment post. Wash temp. 155°F. Rinse temp.180°F.
-
Remove the stainless steel plug to install the detergent probe (provided by your dispenser supplier; CMA does not supply)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>