DEWALT DCE6820B Powered Water Tank Instructions
- September 13, 2024
- Dewalt
Table of Contents
DEWALT DCE6820B Powered Water Tank Instructions
Trouble Shooting
Symptom: After opening a new DCE6820B Powered Water Tank, upon initial start up, the tank supplies no water.
- Check to make sure the suction pipe is placed in the water.
- Check whether the nozzle is open.
If the suction pipe and the nozzle are in the correct positions, the valve core in the pump may have dried out and sticks to the valve seat. If the motor runs when the new machine started but the nozzle can’t spray water, please follow below guide to make the machine run normally:
- Take out the water suction pipe and blow air into it with 2 Bar air pressure. Use your hand to feel the gas flowing out of the nozzle and keep it for more than 5 seconds.
- Restart the machine to test whether it is running normally
DCE6820B POWERED WATER TANK (BARE TOOL)
Nozzle open status
Use an air gun to blow air into the suction pipe
Troubleshooting
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| No water supply | Product is not on or in Wireless Tool Control Mode (WTC), if | |
| applicable. | Switch the product on by pressing the ON mode or turn to WTC mode |
if applicable.
The supply of water in the tank has been used up completely.| Fill the tank.
The nozzle on the water tank is closed.| Open the Nozzle
The quick connect release collar has no connection with the nozzle or cutting
tool.| Press the quick connect release collar firmly onto the nozzle or
cutting tool.
No tank filter installed.| Check the tank filter and, if applicable, install
the tank filter.
Inlet filter or tank filter clogged.| Clean or replace the filter.
Battery is discharged (LED on the product does not show)| Charge the battery
or insert a new battery
Water in the tank or lines is frozen.| Move the product to a warm place and
wait until the ice has melted.
Tank ran continuously for more than 30 minutes.| Turn the tank on and off to
reset.
The battery compartment or control panel got wet.| Remove the battery and wait
for the water to dry. If problem persists, consult DEWALT service.
The water supply has been used and the tank is empty for more than 1 minute.|
Fill the tank and reset the power switch again.
|
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>