Mugen Seiki MBX8R Road Competition Electric Buggy Kit Instruction Manual

: September 17, 2024
: mugen seiki

Mugen Seiki MBX8R Road Competition Electric Buggy Kit

TECHNICAL INFORMATION

Width : 309mm
Wheel Base : 315~320mm adjustable
Gear Ratio : 12.24:1

TECHNICAL INFORMATION

Mania See mene rate her on 2 gene Sta Re eVery Bate Tools Pack) / Rear Exhaust Engine (only chassis kit) / Mutter / Manifold /The contents are subject to change without notice due to product improvements and specification changes.
WARNING: This product CONTAINS CHEMICALS that and known to the state of Califomia to cause cancer, birth defects, or other reproductive harm.
NOTICE: The following items are needed for completion of the MBX8R.
They are not included with this kit (unless noted) and should be obtained from your local hobby shop.
Be sure to read the instructions completely before assembly.

Additional items needed for completion

Additional items are needed to start the engine

Your 2-channel radio system

The servos must be set at the center position before installation.
To set it at a neutral position, turn on the transmitter and receiver.
Set the trim tabs in the center position, and turn off the receiver, and then the transmitter.
The servos will be in a proper neutral position for installation.
Please read the instructions provided with your radio system before using it.

Tools needed

Tools needed for assembly

Screw Chart

These are the actual sizes of the screws included with this kit.

Before you start to assemble the kit, please read the instructions manual to the end.
Apply Super Joint Grease.
Apply Screw Lock Liquid.

Front/Rear Diff

Kit Bag-A1/A2

Center Diff

Kit Bag-A1/A2

Front Gear Box

Kit Bag-B1

Front Lower Arm

Kit Bag-C1/C2

Front Upper Arm

Kit Bag-D1

Front Upright

Kit Bag-D1/D2

Rear Gear Box

Kit Bag-E1

Rear Lower Arm

Kit Bag-F1/F2

Rear Upright

Kit Bag-G1/G2

Rear Upright / Center Diff. Mount

Kit Bag-G1/H1

Servo Saver

Kit Bag-H1

Chassis

Kit Bag-i1

Fuel Tank

Kit Bag-J1

Radio Plate

Kit Bag-K1

Engine

Kit Bag-L1

Kit Bag-L1/01

Linkage

Kit Bag-M1

Shocks

Kit Bag-N1/N2

Front Damper

Kit Bag-N1

Rear Damper

Kit Bag-N1

Fuel Pipe

Kit Bag-01

Air Filter

Kit Bag-01

Tire

Kit Bag-01

Wing

Kit Bag-01

Body

Kit Bag-01

Starting Engine

Troubleshooting Guide

CAUTION To avoid accidents and personal injury, be sure to observe the following.

HANDLING OF THE ENGINE RC CAR:

Engine RC car runs at a very fast, and uses expensive flammable glow fuel for the model. Exhaust sounds sometimes make noise to other people. Operate the model in the area with safety, no trouble, no personal injury, no property damage, and no accident.

After assembling

Be sure to tight screws securely and install all parts.
Make sure that the movable parts work smoothly.
Turn on the switch of the receiver and transmitters, and make sure the steering servo and engine control servo work normally.

Do not operate it:

In a place where many people around
near children
near the residential districts, schools, and hospital
near the road and railroad track
indoors
at early morning and night
at the same time when somebody uses the same frequency
when the battery of the receiver and transmitter weak
When the model behaves strangely

Start to operate

Be sure to observe the following process. Non-observance will make RC cars start suddenly and may lead the damage and unexpected accidents.

Make sure the battery charges fully.
Put the RC car on the starter box and float the tires from the ground.
Turn on the switch of the receiver.
Turn on the switch of the transmitter.
Make sure the steering servo and engine control servo work normally and adjust them correctly.
Put the fuel in the tank, and close the cap securely.
Heat the plug.
Push the back of the RC car on the starter box and start the engine.
- (If the engine is new, follow the instruction manual and be sure to smooth the new engine. If not, the engine will break suddenly by the high rotation.)

Finish to operate

Stop the engine. (Use up the fuel in the tank or force to stop the flywheel that is seen from the bottom of the chassis by the sole of the shoe, etc.)
Turn off the switch of the receiver.
Turn off the switch of the transmitter.

Maintenance after running

Do care after running to keep performance, and to notice the damage and the wear.

Do not leave the fuel in the tank.
Exhaust oil inside the muffler should go outside.
Clean up the sand and mud.
Put the oil on the movable parts such as the shaft carrier, suspension, etc, and the bearing.
ut the rustproof oil (maintenance oil) inside of the engine.

CAUTION: FUEL

The glow fuel for radio control models that are used for the engine RC car is made of a combination of methyl alcohol, oil or composition oil, nitromethane, etc. The flammability of these elements is to be very high, have volatility, and be fully careful of handling and storage.
Only use the glow fuel for radio control models the model shop sells. Other fuels, such as gasoline and kerosene may break the engine, and there is fear of explosion and accident such as a fire.
Never use it.
The flammability of the fuel is very high. Don’t do the fuel lubrication and the preparation for operating near the fire.
Never do the handling of the lubrication inside and mix the fuel in a place where ventilation is bad.
Fuel is harmful. It is dangerous to drink and to inhale the volatile element of the fuel and exhaust. Never do.
Avoid fire, direct sunlight, high temperatures, and near batteries, and store the fuel in cool, dry, and dark places out of children’s reach.
Don’t leave the fuel in the fuel pump and the fuel tank.
There is a danger that fuel leaks out.
Wipe out the spilled fuel with the useless cloth completely.
Remove a cap first and throw the empty fuel can away. Don’t throw an empty can into the fire. There is a danger of an explosion.

CAUTION: ENGINE

Confirm the position of the needle and idling before running.
Be sure to smooth the new engine.
Never remodel the engine and muffler.
There is a danger that it gets burned because the engine and the muffler generate high temperatures for a while after use.
Do not touch the rotating parts at high speed such as clutch bel and flywheel. There is a danger that it gets hurt.
Olf the fuel pipe is choked or deteriorates, the engine may not start and there is a danger the fuel leaks out.
Be sure to put the air filter in. Use the filter that is soaked with air filter oil.
Engine may not start if the air filter is dirty, or choked with sand and dust.

FIRST AID

If you drink fuel by accident, drink large quantities of water and emit it and right after that, see a doctor.
If fuel is within your eyes, wash it away with the water well, and right after that, see a doctor.
If fuel is stuck to the skin, wash it with soap and water
MUGEN SEIKI CO., LTD.
1395617, Ja-cho, Funabashi, Chiba
E-mail:support@mugenseiki.com
www.mugenseiki.co.jp
www.mugenseiki.com
MUGEN SEIKI RACING LTD.
20525 Crescent Bay Drive
Lake Forest, CA 92630, USA
E-mail:support@mugenracing.com
www.mugenracing.com
MSE MUGEN SEIKI Europe Vertriebs GmbH
Auf’m Wasserkamp 3,
D-45881 Gelsenkirchen, Germany
E-mail:info@mugen.eu
www.mugen.eu

Documents / Resources

| Mugen Seiki MBX8R Road Competition Electric Buggy Kit [pdf] Instruction Manual
MBX8R Road Competition Electric Buggy Kit, MBX8R, Road Competition Electric Buggy Kit, Competition Electric Buggy Kit, Electric Buggy Kit, Buggy Kit, Kit
---|---