PULRELAS T1 LED Desk Lamp with Pen Holder User Manual
- September 7, 2024
- PULRELAS
Table of Contents
PULRELAS T1 LED Desk Lamp with Pen Holder
Description
- USB C Input Port
- Wireless Chargung Pad
- Touch Sensor
- USB C Output Port
- USB A Output Port
- LED Indicator
Using Instruction
- Connect the USB power adaptor (not included) to socket 2A or above. A power adaptor will be required.
- Connect the USB cable to the USB connector of the wireless charger.
- Place a Qi-compatible device on the wireless charger to start charging.
- To achieve fast wireless charging, a Quick Charge 2.0 or higher power adaptor will be required.
- Light Button:
- Study: 6000 Kelvin (Pure White) – Reading: 5000 Kelvin (Cool White)
- Sleep: 2800 Kelvin (Warm White)
Specification
- Input: 9V3A
- Output: 15W/10W/7.5W/5W (Phone),5W(USB),5W(Type-c),2W(Lamp)
- Charging Distance: ≤ 8mm
- Conversion Rate: ≥72%
Packing List
- Wireless Charger 1
- USB Cable 1
- User Manual 1
Safety Caution
- Do not disassemble or throw into fire or water, to avoid damage.
- Do not put wireless chargers in quite a hot, humid, or corrosive environment, to avoid circuit damage and leakage.
- Do not place close to a magnetic stripe or chip card such as an ID, credit card, etc., to avoid magnetic failure.
- Keep 30cm at least away from implantable medical devices such as pacemakers and implantable cochlears etc.
- Keep the wireless charger away from children.
- Phone cases may influence wireless charging. Make sure there is no metal in or on your phone case before charging.
FCC STATEMENT
Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The FCC certification of this device refers to RF exposure testing performed in typical operating conditions, where a person is no closer than 20 centimeters from the device surface at all times, except for non-repetitive patterns with transient time intervals in the order of a second. Only in the stated conditions, the device is shown to fully comply with the FCC RF Exposure requirements of KDB 447498.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>