SHARE SUNSHINE S3 3-in-1 Wireless Charger User Manual

September 7, 2024
SHARE SUNSHINE

SHARE SUNSHINE S3 3-in-1 Wireless Charger

Instructions

  1. Connect USB power adaptor (not included) to socket 2A or above. Power adaptor will be required.
  2. Connect USB cable to USB connector of the wireless charger.
  3. Place Qi compatible device on the wireless charger to start charging.
  4. To achieve fast wireless charging, a Quick Charge 2.0 or higher power adaptor will be required.

Specification

  • Input: 9V3A
  • Output: 5W/7.5W/10W/15W (Phone), 3W (Earphone), 2W (for iWatch)
  • Charging Distance: ≤ 8mm
  • Conversion Rate : ≥72%

Packing List

Wireless Charger 1, USB Cable 1, User Manual 1

Caution

  1. Do not disassemble or throw into fire or water, to avoid damage.
  2. Do not put wireless charger in quite hot, humid or corrosive environ- ment, to avoid circuit damage and leakage.
  3. Do not place close to magnetic stripe or chip card such as ID, credit card etc, to avoid magnetic failure.
  4. Keep 30cm at least away from implantable medical devices such as pace- maker and implantable cochlear etc.
  5. Keep the wireless charger away from children.
  6. Phone case may influence wireless charging. Make sure there is no metal in or on your phone case before charging.

FCC

FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:

  1. this device may not cause harmful interference,
  2. this device must accept any interference received, including interference that may cause undesired operation.

CAUTION: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radiofrequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

The FCC certification of this device refers to RF exposure testing performed in typical operating conditions, where a person is no closer than 20 centimeters from the device surface at all times, except for non-repetitive patterns with transient time intervals in the order of a second. Only in the stated conditions, the device is shown to fully comply with the FCC RF Exposure requirements of KDB 447498.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals