Schneider Electric LC1D115P7 Tesys Deca Contactor Instructions
- September 3, 2024
- Schneider Electric
Table of Contents
Schneider Electric LC1D115P7 Tesys Deca Contactor
Specifications
- Product: TeSys Deca Contactor 115A 3P 230VAC
- Manufacturer: Schneider Electric Industries SAS
- Brand: Schneider Electric
- Product Function: Switch on and off the electrical power supply of downstream installation
- Product Reference: LC1D115P7
- Total Product Mass: 2329g
- Product Dimensions: 158mm x 110mm x 132mm
End-of-Life Instructions
Recommendation| Number on
drawing
| Component / Material| Weight (in
g)
| Comment
---|---|---|---|---
To be depolluted| 1| Electronic Board (Communication) >
10cm²
| 18.1g|
To be depolluted| 2| Plastic parts with brominated FR| 150.7g|
Product Description
| Manufacturer identification | Schneider Electric Industries SAS |
|---|---|
| Brand name | Schneider Electric |
| Product function | The main purpose of the product is to switch on and |
off the electrical power supply of a downstream installation with an
electrical and/or mechanical control.
Product reference| LC1D115P7
Additional similar product references| LC1D115, LC2D115,
LC1D150, LC2D150, LC1D115004, LC2D115004;
Total representative product mass| 2329 g
Representative product dimensions| 158 mmx 110mm x 132mm
Accessories| NO
Date of information release| 2024/02/04
Additional information
Legal information
| ****
This product family is in the scope of European Union directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). The product family must be disposed of according to the legislation of the country. This document is intended for use by end-of-life recyclers or treatment facilities. It provides the basic information to assure an appropriate end-of-life treatment for the components and materials of the product.
---|---
In case of special transportation:
transportation method
| NO
Recyclability potential
| ****
54%
| ****
The recyclability rate has been calculated based on the REEECY’LAB tool developed by Ecosystem, for components/materials not covered by the tool, data from the “ECO’ DEEE recyclability and recoverability calculation method” was taken. If no data was found a conservative assumption was used (0% recyclability).
Installation
- Ensure the power supply is disconnected before installation.
- Mount the contactor securely in a suitable location.
- Connect the electrical and/or mechanical control to the contactor as per the installation diagram.
Operation
- After installation, verify all connections are secure.
- Switch on the power supply and test the contactor by activating the control mechanism.
- Observe the proper functioning of the contactor in switching the power supply on and off.
Maintenance
- Regularly inspect the contactor for any signs of wear or damage.
- Clean the contactor if necessary to ensure optimal performance.
- Replace any worn-out components following manufacturer guidelines.
Frequently Asked Questions
Q: How should I dispose of the product at the end of its life?
A: The product must be depolluted and disposed of according to the legislation
of your country. Contact local authorities or recycling facilities for proper
disposal methods.
Q: What is the recyclability potential of the product?
A: The recyclability rate is 54% based on calculations. Ensure to follow
proper recycling procedures to contribute to environmental sustainability.
Contact Schneider Electric Industries SAS Customer Care Center for further assistance or inquiries.
Schneider Electric Industries SAS
Country Customer Care Center
http://www.schneider-electric.com/contar
35, rue Joseph Monier CS 30323
F- 92500 Rueil Maimaison Cedex
RCS Nanterre 954 503 439
Capital social 896 313 776 €
www.se.com
ENVEOLI100405EN_V4
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>