ALASTA LED Clock Time and Temperature User Manual

ALASTA LED Clock Time and Temperature

Product Information

Technical Specifications

• Supply voltage: 12VDC
• Power consumption: Not specified
• Working temperature: Not specified
• Outdoor humidity: Not specified

Product Usage Instructions

Connecting the Power Supply
The clock is powered by DC voltage with a rated value of 12V. Connect the red cable to the +12VDC terminal and the black cable to the 0VDC terminal.

Terms of Use

• Disconnect the clock from the power supply during installation.
• Avoid direct contact with water as the device is not hermetically sealed.
• Clean the clock using only dry or slightly damp cloths, do not use detergents or water.
• Do not use the device in a way that contradicts its intended purpose as the manufacturer is not liable for resulting damages.

Time Setup
To set the current time:

1. Press the touch button for 4 seconds in the time display.
2. To change the time format, press the touch button.
3. To enter the next configuration, hold down the button for 2 seconds.
4. The hour display will start flashing, click the button to set the current time.
5. Hold the button for 2 seconds to move to the next configuration (minutes).
6. Hold down the button again for 2 seconds to select the temperature unit.
7. Leaving the clock stationary will save your changes.

FAQ

• Q: What should I do if the clock stops working suddenly?
  A: Check the power supply connection first. If it’s properly connected and the issue persists, contact customer support for further assistance.

• Q: Can I use this clock outdoors?
  A: It is not recommended to use the clock outdoors due to its sensitivity to humidity and lack of hermetic sealing.

Led watch
Thank you for purchasing our mirror.
We make all our products with the greatest attention to detail. We are one of the leading brands that produce mirrors in Europe, so you can be sure you get the highest quality product. Use your mirror according to its absolute purpose by following the descriptions, conditions and provided information in this manual.

The schema

Connecting the power supply

• Red cable 12 VDC
• Black cable 0 VDC

The clock displays the time This device is powered by DC voltage voltage with a rated value of 12V. After its disappearance, the time is still measured, so that when the device is powered again, the time is correct.

Terms of use

• The clock should be disconnected from the power supply during the installation.
• This device is not hermetically sealed and cannot be used in an environment where there is direct contact with water.
• Use only dry or slightly damp cloths for cleaning – do not use detergents or water.
• The manufacturer is not liable for any damage resulting from using the device contrary to its intended use.

Technical specifications

• Supply voltage:  6-16VDC
• Power consumption:  max 100mA
• Working temperature:  0 do +60°C
• Outdoor humidity: max 80%

Time Setup

• To set the current time, press the touch button for 4 seconds in the time display.
• You can change the time format by pressing the touch button. To go into the next configuration, hold down the button for 2 seconds. The number responsible for displaying the time(hour) will start flashing.
• By clicking the button you can set the current time. Hold the button for 2 seconds to go to the next configuration (minutes).
• Hold down the button again for 2 seconds to select the temperature unit. Leaving the watch stationary will save your current changes.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>