iHomeBlinds AM35, AM45 Multi Electronic Limit Wi-Fi Motor User Manual

Table of Contents

Motor Cable

Programming
Change direction
Limit position setting
A maximum of six different limit positions can be set, the furthest two positions called the UP and DOWN limit position, others called the middle limit positions;
When the first limit position is the UP limit position(as right illustration), all other limit positions can only be set below this position; the same thing, is when the first limit position is the DOWN limit position, all other limit positions can only be set above this position;
Every limit position can be fine-tuned or deleted separately(The first limit position can only be fine-tuned but can’t be deleted separately. It can be deleted when deleting all memories );
The motor stops at the next limit position after accepting one UP/DOWN order. When it reaches the UP limit position, the UP order is no use anymore; when it reaches the DOWN limit position, the DOWN order is no use;
Press the UP/DOWN button twice on the transmitter at the speed of once a second, motor will go directly to the UP/DOWN limit position without any stop at the middle limit
First limit position setting
(If there’s no action within 30’s, the motor will exit from limit position preparation automatically)
Other limit position-setting
Limit position fine-tuning
Delete the limit position
* (The first limit position can’t be deleted)
Dot move and continuous move conversion
Add the new transmitter
Delete single-channel memory
Delete all the memories

APP Download
Scan the QR code to download the Tuya APP
Device setup
Click “Add Device” or click the “+” in the upper right corner.
Click the “small home appliance” on the left
Click the “curtain”
2.4GHz Wi-Fi network, enter the device-Binding Wi-Fi password, and Click “Confirm”.
Short press the motor “PROG” button 4 times and then long press 3 seconds at the fifth time to enter the distribution network mode. (When pressing the motor “PROG” button the fifth time, the motor will jog once in the first second, then jog once in the third second). click “Make sure the indicator lamp is fast flashing”
Click on Blink Quickly
Waiting for the network configuration to complete. (Motorjogsg twice during the connection process means that the Wi-Fi configuration is successful but not connected to the router; the motor jogs once when it connected to the router and connected to the cloud)
After the configuration is complete, you can modify the device name, and click “Finish”.
Operation interface
APP Control interface is shown in the following figure

Read User Manual Online (PDF format)