FloraFlex 700 Watt Full Spectrum LED Grow Light Instruction Manual

Table of Contents

Power: 700W
Light Type: Full Spectrum Custom Diodes LED Grow Light
Components: 4x Diode Bars, 4x End Pieces, 2x Structure Bars, 1x Driver, Hardware bag (including 4x Center Pieces, 2x Cables, 24x Screws, 2x Brackets)

Frequently Asked Questions

Q: How do I know if all connections are secure before powering the device?
- A: Ensure that all screws are tightened, brackets are securely in place, and cables are properly connected without any loose ends.
Q: Can I use this LED grow light for indoor plants?
- A: Yes, this LED grow light can be used for indoor plants to provide full spectrum lighting for optimal growth.

PRODUCT WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

Ensure your power source conforms to the electrical requirements of this product.
Check your local code restrictions for additional safety measures that may be needed for a proper code compliant installation.
Read all instructions before installing and using this product.
If you are unfamiliar or have doubts about performing this product’s installation, seek the services of a qualified, trained, and licensed professional. Inappropriate installation will void this product’s warranty.
Do not attempt to hardwire this product. Performing any retrofitting actions may result in personal injury and/or electrical damage, and will void this product’s warranty.
This product must not be used in potentially hazardous locations such as flammable, explosive, chemical-laden or wet atmospheres.
Do not cover power cords with rugs or other fabric materials.
Safety precautions should be exercised during the installation, operation, and maintenance of this product.
Do not block or tamper with this product in any manner while it is in operation as it may cause electric shock, fire, or damage to this product.
Do not depend on the on/off programming as the sole means of shutting power from this product. Unplug the power cord before installing, servicing, or moving this product.
Do not operate this product while its cord is damaged, or if it malfunctions, has been dropped, or is damaged in any manner.

Diode Bars

Structure Bars

Driver

Hardware

Cables

STEP 1

Locate the 4 end piece diode bars, each with 4 screws on the back. Position them at slots #1, #2, #7, and #8 as indicated.
Place the other 4 diode bars, each with 2 screws, at slots #3, #4, #5, and #6.

STEP 2

Align the 2 structure bars with the diode bars. Ensure each screw fits through the corresponding hole on the structure bar.

STEP 3

STEP 1

STEP 2

STEP 3 (Option A)

STEP 3 (Option B)

STEP 4

Note: Ensure all connections are secure before powering the device.

STEP 1

Insert the spring nuts into the unistrut.
Flip the driver upside down and align the screw holes with the spring nut holes.
Secure with the plastic knob screws.

STEP 2

Note: Ensure all connections are secure before powering the device.

Scan

| FloraFlex 700 Watt Full Spectrum LED Grow Light [pdf] Instruction Manual
700 Watt Full Spectrum LED Grow Light, 700 Watt, Full Spectrum LED Grow Light, LED Grow Light, Grow Light
---|---