HAVIT HV2902 Pinta Step Light Installation Guide

Table of Contents

Pinta Step Light
Installation Instructions

Model No.	HV2902	HV2902-AB	HV2904T	HV2904T-AB	HV2905T-12V
Name	Pinta
Material	316 Stainless Steel	Brass	316 Stainless Steel	Brass	316

This product must be installed by a qualified electrician according to AS/NZS 3000.
Ensure all electrical mains are disconnected before any installation.
Do not exceed maximum wattage restrictions for globes: 240V GU10 = 35w / 12V MR16 = 20w
Modification of this product will void any warranty.
Havat Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
When installing low voltage fittings, Voltage to fitting must be within +or- 5% of voltage required and cannot be installed more than 25m from LED Driver, if not within this allowance warranty will be voided.
Aluminium and 304SS fittings must not be installed within 2km of any salt water environments.
When installing copper fittings, gloves must be worn to avoid any oils transferring to fitting.
All 316 stainless steel fittings must have regular cleaning maintenance to avoid any tea staining from forming on fitting. (Warranty does not cover Tea Staining)
All o-rings and seals must be in place correctly to maintain warranty.
These instructions may be updated at any time due to product improvements, Please visit website for most current installation instructions.

Make sure that the electrical circuit is free of voltage (master switch off )
Remove screws from front of fitting as set aside.
Install base plate in desired location
Using an appropriate 12v LED Driver or transformer – DO NOT CONNECT LIGHT FITTING DIRECTLY TO 240V
Connect the cable into terminal block – Positive from cable run to positive of fitting then connect the neutral – If more than one fitting installed, wiring must be done in parallel.
Insert globe into fitting making sure globe can be used with selected driver.
Reattach face onto fitting making sure seals are still in place and screws are tight to avoid water penetration into fitting
Apply silicon around edge of fitting to prevent any water from getting inside to electrical connections.
All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.

Make sure that the electrical circuit is free of voltage (master switch off )
Remove screws from front of fitting as set aside.
Using an appropriate 12v LED Driver – DO NOT CONNECT LIGHT FITTING DIRECTLY TO 240V
Connect the cable – If more than one fitting installed, wiring must be done in parallel.
Strip back the cable on both fitting and cable run and twist the positive cables together. Then connect neutral cables together
Solder all joins using solder and either a heat gun or butane gas torch.
Cover connections using an adhesive lined heat shrink or gel cap to make connection watertight. Failure to do this will void warranty.
Heat the heat shrink or crimp the gel cap making sure all connections are covered.
Install base plate in desired location
Fitting is preset to 3000k, To change move switch above PCB to desired colour temperature
Reattach face onto fitting making sure seals are still in place and screws are tight to avoid water penetration into fitting
Apply silicon around edge of fitting to prevent any water from getting inside to electrical connections.
All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.