HAVIT HV2860 Series Tekk Deck Light Installation Guide

August 23, 2024
havit

HAVIT HV2860 Series Tekk Deck Light

Product Usage Instructions

Safety Precautions

Before starting the installation process, please ensure to read and understand all safety instructions provided in the manual. It is recommended to wear appropriate safety gear and clothing during installation.

Installation Steps

  1. Ensure the power source is switched off before starting the installation.
  2. Mount the Tekk Deck Light securely in the desired location using appropriate fixtures.
  3. Connect the wiring following the provided sample wiring diagram. Make sure all connections are secure and insulated.
  4. If unsure about the wiring or installation process, contact a licensed electrician for assistance.
  5. Once installed, test the light to ensure proper functionality before completing the installation.

FAQ

  • Q: Is the Tekk Deck Light suitable for outdoor use?
  • A: Yes, the Tekk Deck Light is rated IP67, making it suitable for outdoor installation.
  • Q : Can the lamp wattage be adjusted?
  • A: No, the lamp wattage of the Tekk Deck Light is fixed at 3w.
  • Q : Is the Tekk Deck Light compatible with dimmer switches?
  • A : No, the Tekk Deck Light is not dimmable.

Product Specifications

Dimensions

Important Safety Issues

  • This product must be installed by a qualified electrician according to AS/NZS 3000.
  • Ensure all electrical mains are disconnected before any installation.
  • Modification of this product will void any warranty.
  • Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
  • When installing low voltage fittings, Voltage to fitting must be within or- 5% of the voltage required and cannot be installed more than 25m from the LED Driver, if not within this allowance warranty will be voided.
  • Aluminium and 304SS fittings must not be installed within 5km of any saltwater environments.
  • This fitting is not suitable for inground installation
  • All o-rings and seals must be in place correctly to maintain warranty.
  • These instructions may be updated at any time due to product improvements, Please visit the website for the most current installation instructions.

Sample Wiring Diagram

Steps for Installation

  1. Make sure that the electrical circuit is free of voltage (master switch off)
  2. Make a hole where the fitting is to be placed using dimensions provided on line drawings,
  3. Use an appropriate 12v DC LED Driver – DO NOT CONNECT LIGHT FITTING DIRECTLY TO 240V
  4. Connect the cable – If more than one fitting is installed, wiring must be done in parallel.
  5. Strip back the cable on both fitting and cable run and twist the positive cables together. Then connect neutral cables
  6. Solder all joins using solder and either a heat gun or butane gas torch.
  7. Cover connections using an adhesive-lined heat shrink or gel cap to make the connection watertight. Failure to do this will void the warranty.
  8. Heat the heat shrink or crimp the gel cap making sure all connections are covered.
  9. Insert fitting into the hole.
  10. Apply silicon around the edge of the fitting to prevent any water from getting inside to electrical connections.
  11. All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.

Must be installed by a licensed electrician

Warranty Terms & Conditions

Additional Information

Contact

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

havit User Manuals

Related Manuals