tp-link X80 AX6000 Whole Home Mesh WiFi 6 System User Guide
- June 3, 2024
- tp-link
Table of Contents
X80 AX6000 Whole Home Mesh WiFi 6 System
User Guide
X80 AX6000 Whole Home Mesh WiFi 6 System
Enable UPNP to allow your local network to dynamically open ports for
applications like gaming.| Enable Fast Roaming to allow your wireless devices
to switch connection to different Decos.| Enable Beamforming to concentrate
Wi-Fi signal towards connected
devices for stronger connections.| Toggle off LED to turn off the light on
Deco. Configure the Night Mode to
turn off the LED light at bedtime only.
---|---|---|---
| 
| 
|
Change the operation mode.
Note: When the Deco works in Access Point mode, advanced features such as
IPv4, Address Reservation, Port Forwarding, and DHCP server are not
available.| Set connection alerts to receive notifications once the clients
connect to or disconnect from Deco.| Set notifications to receive alerts in
the notification bar.
---|---|---
| 
|
WPS
WPS (Wi-Fi Protected Setup) helps you to quickly and securely connect a client to the network with a tap without entering any password.
- Tap > WPS.
- Tap the WPS icon on Deco app and then on your client.
- Your device has connected to the network successfully if shown as below.
Managers
Add friends and family members to help manage your network. Each manager
should have their own TP-Link ID.
Note: Managers can not modify owner’s account, add other accounts, or set
manager privileges.
Tap > Managers, and follow app instructions to add other TP-Link ID accounts
as managers.
Set privileges for managers.
Note: Privileges may vary slightly depending on the model, the current
operation mode, and software version you have. Remove managers.
Control Your Deco with Alexa
Alexa Integration allows you to control your Deco using Amazon’s Alexa voice
service. You can control and customize your home network by giving simple
voice commands to Alexa, such as enabling the Guest Network, turning off your
Deco LEDs, and more.
Follow the steps below to use Alexa voice commands to control your Deco
network.
Tip: To know more about how to set up Alexa Integration in Alexa app,
refer to https://www.tp-link.com/support/faq/1571/.
Note: This feature is currently available in English (US), English (UK),
German and Japanese.
In the Deco app, tap to open the menu, tap Friends of Deco > Alexa >
TP-Link Router Skill, then follow the app instructions to complete the
setup.
Troubleshooting
Solutions to common problems during setup or use are provided here for
reference. Follow the steps and the provided link below to diagnose and solve
problems you might experience with your Deco.
If problems still exist, contact us: https://www.tp-link.com/support
Q1. What should I do if I fail to configure the main Deco and get stuck on
“We couldn’t find Deco”?
– Refer to the guide https://www.tp-link.com/support/faq/2239/ or follow the
video https://youtu.be/2HYuEYS9XJM
Q2. What should I do if I fail to configure the satellite Deco and get stuck
on “We couldn’t find another Deco”?
– Refer to the guide https://www.tp-link.com/support/faq/1447/ or follow the
video https://youtu.be/iVgDzoo16T4
Q3. What should I do if I fail to configure the main Deco and get stuck on
“Testing Internet Connection”?
– Refer to the video https://youtu.be/OSUrGdWH-i0
Q4. What should I do if my wireless devices cannot connect to Deco?
– Refer to the guide https://www.tp-link.com/support/faq/2718/
Q5. What should I do if Deco suddenly lost internet access?
– Refer to the guide https://www.tp-link.com/support/faq/1454/
Q6. How can I find a suitable spot for my Deco?
– Refer to the guide https://www.tp-link.com//support/faq/1446/
Q7. What can I do if the Deco app isn’t working properly?
– Refer to the guide https://www.tp-link.com/support/faq/1456/
Authentication
**FCC Compliance Information Statement
Product Name: AX6000 Whole Home Mesh Wi-Fi 6 System
Model Number:** Deco X80
| Component Name | Component Model |
|---|---|
| I.T.E POWER SUPPLY | T120200-2B4 |
Responsible party:
TP-Link USA Corporation
Address: 10 Mauchly, Irvine, CA 92618
Website: http://www.tp-link.com/us/
Tel: +1 626 333 0234
Fax: +1 909 527 6804
E-mail: sales.usa@tp-link.com
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this equipment. Such
modifications could void the user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This device and its antenna must not be co-located
or operating in conjunction with any other antenna or transmitter.
“To comply with FCC RF exposure compliance requirements, this grant is
applicable to only Mobile Configurations. The antennas used for this
transmitter must be installed to provide a separation distance of at least 20
cm from all persons and must not be co-located or operating in conjunction
with any other antenna or transmitter.”
We, TP-Link USA Corporation, has determined that the equipment shown as above
has been shown to comply with the applicable technical standards, FCC part 15.
There is no unauthorized change is made in the equipment and the equipment is
properly maintained and operated.
FCC Compliance Information Statement
Product Name: I.T.E POWER SUPPLY
Model Number: T120200-2B4
Responsible party:
TP-Link USA Corporation
Address: 10 Mauchly, Irvine, CA 92618
Website: http://www.tp-link.com/us/
Tel: +1 626 333 0234
Fax: +1 909 527 6804
E-mail: sales.usa@tp-link.com
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
OPERATING FREQUENCY: 2400-2483.5MHz,5250-5350MHz, 5725-5850MHz
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
We, TP-Link USA Corporation, has determined that the equipment shown as above
has been shown to comply with the applicable technical standards, FCC part 15.
There is no unauthorized change is made in the equipment and the equipment is
properly maintained and operated.
CE Mark Warning
This is a class B product. In a domestic environment, this product may cause
radio interference, in which case the user may be required to take adequate
measures.
OPERATING FREQUENCY(the maximum transmitted power)
2400 MHz -2483.5 MHz (20dBm)
5150 MHz -5250 MHz (23dBm)
5250 MHz -5350 MHz (23dBm)
EU Declaration of Conformity
TP-Link hereby declares that the device is in compliance with the essential
requirements and other relevant provisions of directives 2014/53/EU,
2009/125/EC, 2011 /65/EU and (EU) 2015/863.
The original EU Declaration of Conformity may be found at https://www.tp-
link.com/en/support/ce/
RF Exposure Information
This device meets the EU requirements (2014/53/EU Article 3.1a) on the
limitation of exposure of the general public to electromagnetic fields by way
of health protection.
The device complies with RF specifications when the device used at 20 cm from
your body.
National restrictions
Attention: This device may only be used indoors in all EU member states
and EFTA countries, and Northern Ireland.
| AT| BE| BG| CH| CY| CZ| DE| DK
---|---|---|---|---|---|---|---|---
EE| EL| ES| Fl| FR| HR| HU| IE
IS| IT| LI| LT| LU| LV| MT| NL
NO| PL| PT| RO| SE| SI| SK| UK(NI)
UKCA Mark
UK Declaration of Conformity
TP-Link hereby declares that the device is in compliance with the essential
requirements and other relevant provisions of the Radio Equipment Regulations
2017.
The original UK Declaration of Conformity may be found at https://www.tp-
link.com/support/ukca/
National restrictions
Attention: This device may only be used indoors in Great Britain.
Canadian Compliance Statement
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of the device.
Caution:
The device for operation in the band 5150–5250 MHz is only for indoor use to
reduce the potential for harmful interference to co-channel mobile satellite
systems;
DFS (Dynamic Frequency Selection) products that operate in the bands 5250-
5350 MHz.
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Industry Canada Statement
CAN ICES-3 (B)/NMB-3(B)
Equipment name:
AX6000 Whole Home Mesh Wi-Fi 6 System Deco X80| Type designation (Type)
---|---
Unit| Restricted substances and its chemical symbols
Lead (Pb)| Mercury (Hg)| Cadmium (Cd)| Hexavalent chromium (Cr`6)|
Polybrominated biphenyls (PBB)| Polybrominated diphenyl ethers (PBDE)
PCB| | | | | |
| | | | | |
| –| | | | |
| –| | | | |
Note 1: “Exceeding 0.1 wt %” and “exceeding 0.01 wt %” indicate that the
percentage content of the restricted substance exceeds the reference
percentage value of presence condition.
Note 2: “ ” indicates that the percentage content of the restricted
substance does not exceed the percentage of reference value of presence.
Note 3: The “−” indicates that the restricted substance corresponds to
the exemption.
Safety Information
- Keep the device away from water, fire, humidity or hot environments.
- Do not attempt to disassemble, repair, or modify the device. If you need service, please contact us.
- Do not use damaged charger or USB cable to charge the device.
- Do not use any other chargers than those recommended.
- Do not use the device where wireless devices are not allowed.
- Adapter shall be installed near the equipment and shall be easily accessible.
- This product uses radios and other components that emit electromagnetic fields. Electromagnetic fields and magnets may interfere with pacemakers and other implanted medical devices. Always keep the product and its power adapter more than 15 cm (6 inches) away from any pacemakers or other implanted medical devices. If you suspect your product is interfering with your pacemaker or any other implanted medical device, turn off your product and consult your physician for information specific to your medical device.
- Use only power supplies which are provided by manufacturer and in the original packing of this product. If you have any questions, please don’t hesitate to contact us.
- Operating Temperature: 0°C~40°C (32°F~104°F)
Please read and follow the above safety information when operating the device. We cannot guarantee that no accidents or damage will occur due to improper use of the device. Please use this product with care and operate at your own risk.
Explanation of the symbols on the product labe
| Symbol | Explanation |
|---|---|
| Alternating current | |
| **** | DC voltage |
| Caution | |
| **** | Operator’s manual |
| Indoor use only |
| Class II
equipment
| Energy efficiency Marking
| Polarity of d.c. power connector
| RECYCLING
This product bears the selective sorting symbol for Waste electrical and
electronic equipment (WEEE). This means that this product must be handled
pursuant to European directive 2012/19/EU in order to be recycled or
dismantled to minimize its impact on the environment.
User has the choice to give his product to a competent recycling organization
or to the retailer when he buys a new electrical or electronic equipment.
References
- Link: Simple, secure one-click payments
- WiFi Networking Equipment for Home & Business | TP-Link
- How can I find a suitable spot for my Deco? | TP-Link Australia
- CE Regulatory Compliance | TP-Link
- TP-Link Product Support - Wireless Networking Equipment Support
- What can I do if the Deco app isn't working properly | TP-Link
- What is Alexa Integration? | TP-Link United Kingdom
- Main Deco Failed to Complete Setup | TP-Link
- Cannot connect to Deco Wi-Fi | TP-Link
- Regulatory Compliance | TP-Link