ALMOST HEAVEN SAUNAS 30 Inch LED Light Bar Installation Guide
- August 24, 2024
- ALMOST HEAVEN SAUNAS
Table of Contents
ALMOST HEAVEN SAUNAS 30 Inch LED Light Bar
IMPORTANT SAFETY INSTRUCTIONS
DANGER: Indicates a hazardous situation that, if not avoided, will result
in death or serious injury.
WARNING: Indicates a hazardous situation that, if not avoided, could
result in death or serious injury.
CAUTION : Indicates a hazardous situation that, if not avoided, could
result in minor or moderate injury.
NOTICE: Indicates information considered important, but not hazard-
related.
FOLLOW SAFETY INFORMATION IN THIS DOCUMENT TO AVOID SERIOUS INJURY OR
DEATH
REFER TO YOUR LOCAL BUILDING CODES FOR ANY SPECIFIC INSTALLATION
REQUIREMENTS
ALL ELECTRICAL WORK NEEDS TO BE COMPLETED BY A LICENSED ELECTRICIAN.
FAILURE TO DO SO COULD CAUSE
INJURY OR DAMAGE TO THE HEATER.
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
REFERENCE SAUNA AND/OR HEATER MANUALS FOR FURTHER SAFETY INFORMATION
LED LIGHT BARS
CAUTION
- Do not alter the sauna in any way, unless explicitly instructed in this manual. Altering the sauna could lead to structural damage, increasing the risk to bodily harm.
Almost Heaven Saunas offers two sizes of LED light bars for saunas. Each light
bar includes a function switch and power supply. The light itself is mounted
to a cedar deflector bar that conceals the LED and directs the light to the
wall of the sauna. The LED bar can be easily mounted anywhere in the sauna and
can be mounted horizontally, vertically, or below the benches depending on
your preference.
INSTALLATION
Step 1: Position the LED bar at the desired location in your sauna. Level
the LED bar and attach to the sauna wall using the screws provided.
Step 2: Locate where you want the cord to exit the sauna. Drill a 5/8”
hole through the sauna wall. Feed the power cord coming from the LED bar
through the hole so that the power switch remains in the sauna.
Step 3: On the exterior of the sauna connect the power supply to the LED
bar cord. NOTE: Be sure the connection is secure and the nut is firmly hand-
tightened. Mount the power supply to the exterior sauna wall, ceiling or other
place where you can secure with either screws or small nails (not included).
Plug the power supply into a 110v outlet and turn on the On/Off LED switch.
Operation of Power Switch
The LED power switch has a single button for on/off functions as well as mode
selection. Hold down the button for about 3 seconds to switch LED modes. Modes
range from slow strobe to fast and then to solid. HOLD the button down and
watch the LED cycle through the modes every 3 seconds. When the mode you
desire appears, let go of the button. The LED is set to this mode until you
change the mode setting again. Once in the mode setting you desire you can
increase the intensity of the LED but holding down the + or – buttons. It is
recommended that you turn the LED off when not in use.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>