CRATES2GO 36x24x24 Plywood Shipping Crate Instruction Manual
- August 22, 2024
- CRATES2GO
Table of Contents
36x24x24 Plywood Shipping Crate
Instruction Manual
CRATE ASSEMBLY INSTRUCTIONS
THANK YOU FOR YOUR RECENT CRATE PURCHASE. PLEASE REFER TO THE INSTRUCTIONS
BELOW FOR ASSEMBLING YOUR CRATE.
TRBBED VERSION
NOTE: ALL CRATE PANELS HAVE PILOT HOLES FOR SCREWS. THESE HOLES MUST FACE
OUT FOR THE BEST RESULTS.
ASSEMBLING YOUR TABBED CRATE
STEP ONE. ASSEMBLE THE SIDE WALLS FIRST BY SLIDING THEM TOGETHER AS SHOWN
IN THE IMAGE BELOW. THIS WILL CREATE A PERIMETER. MAKE SURE THE PILOT HOLES
FACE OUTWARD. STEP TWO. ATTACH THE SIDE WALLS TO EACH OTHER USING THE SCREWS
PROVIDED. STEP THREE. PLACE AN END PANEL ON TOP OF THE SIDE WALL PERIMETER.
AGAIN, MAKE SURE THE PILOT HOLES ON THE END PANEL FACE OUTWARD. 
STEP THREE. ATTACH THE END PANEL TO THE SIDE WALLS USING THE SCREWS
PROVIDED. YOUR TABBED CRATE IS NOW READY TO BE FILLED. ONCE IT IS PACKED,
ATTACH THE EMAINING PANEL USING THE SCREWS PROVIDED.
CAUTION: CRATES MAY HAVE SPLINTERS.
WORK GLOVES ARE ADVISED.
SCREWS ARE THE PREFERRED METHOD OF BUILDING YOUR CRATE. NAILS CAN BE
SUBSTITUTED BUT NOT ADVISED. HOWEVER, AVOID STAPLES.